Reseñas de clientes para VEVOR Cable Manual Pelacables, Máquina Peladora de Cables de Cobre, Pelacables Múltiples de 25 kg, Máquina Peladora de 10 mm con Certificación CE con Asa Ajustable para Procesamiento del Arnés

After debating on it purchase, because of the price as well as not wanting to throw money down the drain, I pulled the trigger. Upon it's arrival, the sheer weight of this machine I had a good feeling that I was not going to be let down. Small wire, no problem, normal housing wire flat, again no problem. Soft #2 insulated wire where other machines had failed...No problem! Awesome!! I have found the easiest and fastest way to peel the butter coating off is to prevent cut my lengths to about 2 feet. I get a pile of about 50-100 pieces and run them through as fast as I could. This bad boy took it all, dropping them out the other end, into the box the machine came in, lol. Then I'd sit on my stool and peel all the copper from it's coating smiling the whole time! I definitely recommend this machine, it is worthy. I have not yet found a big enough wire to test it out completely yet.

Received promptly, good build quality, should do the job. Have not had chance to use.

Machine correspondant à mes attentes livrer rapidement

Works great 👍

Máquina perfecta para la recuperación de retales de cable.

This is the lower end of the wire strippers but it does the job well once you figure out the ideal position for the cable. The instructions are vague so the bottom line is the cable needs to be lower than the cutting point

Es un pelador estupendo

Tolles Maschine. Wenn die Einstellung richtig gewählt ist knackt sie die härtesten Umhüllungen. Für starre und flexibele Kabel in jedem angegebenen Durchmesser geeignet. Leider kein Rückwärtsgang für ev. eingeklemmte Kabel.

Funktioniert.

That machine works very well and as intended. What I don't like is the instructions. The only reason I knew I needed to install the vent for the gear box was after reading about it on another review. NO where in the instructions does it inform what to do with the vent cap. More instruction on how to use the guide plates would be helpful also. I found that lowering the guide plate so the wire has to bend up to go over the rollers helped keep it in the "V" so the knife wheel cuts the sheathing as needed. I was just about to ask for a return until I tried it one more time since I have a lot of wire to strip. I am glad I did and was able to figure out how to mount the guide.