Reseñas de clientes para VEVOR Grada de Arrastre, Niveladora de Entrada de Acero Q235 con Barras Ajustables y Enganche de Pasador, Barra de Remolque de 940 mm Soporta hasta 22,7 kg Ideal para Tractores Todoterreno, UTV

I used this on a new 700’ Knippa rock driveway. It did a great job except it leaves two lines. I’m sure I can figure out the cause. It’s a good purchase. The instructions are incorrect regarding the hardware on either end of the pull bar. I wrote Vevor and got a response. Just know the instructions are wrong. Trust your gut and you’ll be correct.

Works good. But wish manufactur would have used lock nuts. In the process of using our drag 2 of the bolts fell out and were lost. Now I'm replacing all nuts with lock nuts.

We are adapting this to work under a well worn zero turn mower allowing it to raise & lower like the deck

Works well for smoothing out sections that have been excavated. Tows very easily and does a nice job lightly covering grass seed.

Efficace avec un poids dessus ,sans poids trop léger sut sur les mottes de taupe . Tracté avec un tracteur tondeuse. Structure léger en cornières en 2 mm d'épaisseur il aurait au minimum de la cornières en 4 ou 5 millimètres d'épaisseur Avoir dans le temps mais j'ai un doute !!!!

absolute crap, bent on first use, steel too soft for its purpose

Have not used yet but material is very thin and had to beat on it to get it to go together. The fit and finish is close to the worst I have ever seen. I’m a welder and could have made this but have so busy I decided to buy it his. Design seems to be ok but will definitely need to replace with thicker material.

Well, it levels for sure but a design flaw is that if you have weeds or debris you have to manually lift the drag up on each pass in order to not keep dragging the debris around. Wish there was some sort of release mechanism that would lift up the back piece when you pull a handle or something because you still end up doing manual work to rake the debris up afterwards. This device would be good for clean surfaces the just need to be smoothed out.

One of the holes required to connect the spreader to the tow bar was not punched during manufacturing. You can see the failed attempt. The worker just strapped it with foam for shipping and packed it. Ill now need to find tools and punch the hole out myself. A real inconvenience.