Reseñas de clientes para VEVOR 1450 W Taladro Magnético, Taladro de Columna Magnético Portátil de 12800 N con 6 Brocas de Perforación, Diámetro de Perforación de 50 mm, Velocidad Variable para Mejoras para el Hogar

alles bestens Danke

Sehr gutes Preisleistungsverhältnis Die ersten Testbohrungen haben mich sehr poestiv beeindruckt

Ich bin überaus begeistert von der Maschine: Kompakt, kraftvoll, präzise und das zu einem Hammerpreis. Der Innenrundlauf der Weldonaufnahme beträgt 0,03 mm, der Rundlauf des Bohrfutters am eingespannten Werkzeug beträgt 0,1 mm. Das sind Traumwerte für Stahlbauer und für Feinmechaniker wie mich immer noch sehr gute Werte, gemessen an dem Preis. Lediglich der Rechts-/Linkslaufschalter ist verkehrt herum gepolt, aber das kann man mal selbst beheben. Die Führungen haben noch einen kleinen Spritzer Öl so wie eine minimale, aber problemlose Justage zur geschmeidigen Schlittenführung benötigt. Eine Ersatzteilquelle wäre auch wünschenswert. Ansonsten: Top!

Good deal for the price and my limited use. Only issue after drilling less than a dozen holes are the internal wire splices have a poor connection and melted, so at first the mag wouldn't work, then the drill motor wouldn't start. Replaced with spade connectors, and it's fine now .

good product. recommend to buy. price is OK. Quality is good. I have received package within 4 days.

It is amazing how well this unit works. Vevor makes cheap tools, some good, some not so good. This is great. Variable speed, reversing, decent magnet strength. It is well built, and even comes with a starter pack of bits. I have a Milwaukee " made in USA" unit, which is certainly top of the line. This is not ,but does compare with Milwaukee's new made in China models. Get it while you can! BTW. The drill chuck adapter weld-on shank was oversized, so wasn't able to use it.

Máquina como descrição recomendo

The best drill since they started slicing bread. It drilled 264 5/8" without any problems, straight out of the box. I bought the S&F standard annular cutter set and couldn't have been more impressed. The speed and accuracy of the hole size will blow your mind. I turned down the speed to setting number 4 on the drill and it cut without any chatter and a tip temperature of 75 to 95 degrees F. This was thru 3/4" steel and took around 20 seconds per hole. I used Winona van Norman cutting fluid cut to 15% with water.

Odličan snažan alat

This is probably the smartest way of saving money. We drill more then 50 holes in 10mm steel beams. The only thing we had to do is to re-tighten the electrical connection as the magnetic part got disconnected few times. I recommend to use the tightening strap for safety. Otherwise, I fully recommend it