Reseñas de clientes para VEVOR Soporte de Rueda de Motocicleta Capacidad de 816,5 kg Calzo de Rueda Diámetro de 381-558,8 mm Ancho de 76,2-203,2 mm Soporte de Transporte de Acero para Remolque Taller Garaje

I have a 21", 90 width front wheel which is a little thin for this so doesn't hold the 250kg bike secure enough. I have a simple solution: kick down sidestand, put a little stone under it and done. No wind is strong enough to tip the bike like that. You can check it out on my youtube channel @onthepegs

Bon rapport qualité prix

Decent build quality, cones with the hardware to install , although I used larger washers, handled my KLR650 with ease.Can't complain for the price. Would recommend this unit.

Krever modifisering før bruk. Begge platene er "slarkete" når framhjulet er på plass slik at sykkelen ikkje står stødig og risikerer å velte (Yamaha XMAX 300). Ved å borre nye hull i framplaten for å skru denne fast samt sette på ekstra skiver blei det bedre. Sjølve konstruksjonen er av god solid kvalitet og veier 17 kilo.

I had to make two alterations to make this usable. I didn’t want to bolt it to the floor so I fixed a 600 mm long piece of 40 x 40 steel angle to the front. Some rubber strips under this stopped it sliding around and makes the whole thing very stable. With the bike in the stand, the shiny plastic coating on the base allows the tyre to ‘squirm’ sideways a lot and the bike is not held upright with any security at all. I overcame this by bolting two short 50x40 timber sections to the base in close contact to either side of the tyre wall. The tyre can’t move sideways and the bike stays vertical. Both these mods could be done by Vevor!

Round head bolts not ideal for the thickness of the metal, the square hole turned round on hand tightening, instead should have a standard bolt head so can be held in place with a tool.

Vevor claimed would work on my 2026 Indian scout bobber. Useless with my bike

Harley Davidson mit 21" Voderrad geht leider nicht!!! Musste ein neues Loch bohren und jetzt passt es

One of the pins need to be pounded in and out with hammer. (Holes aren't lined up properly) Not great for on the fly adjustments as tools are required to do so.

I bought this to fit in the motorcycle shelter I bought from vevor. The shelter was too small for my bike so I thought I'll stabilised the bike straight up with this rack. It's not easy to see what size is the front wheel to fit in, so it takes a little while of trial and error. Not very stable for the front wheel, and doesn't fit in the bike shelter. I definitely wouldn't recommend it unless it's for inside a garage and a light bike. Delivery took much longer than with my first order.