Reseñas de clientes para VEVOR Máquina de Soldadura MIG Sinérgica de 130 A, Multiproceso 2 en 1 con Núcleo Fundente MIG a Gas/sin Gas, con Tecnología de Inversor IGBT y Pantalla de Visualización Digital, Espesor ≤ 4 mm, Negro

The instruction manual sucks. It’s so hard to understand it don’t give you any of the settings that I’m used to the hell with the metric. Remember, we’re in America and I’ve contacted your customer service to buy a longer ground cable, which is too damn short nobody ever gets back to me

Did not come with wire

This machine is terrible. If you get 15 minutes of use before it flashes and burns the wire back, your lucky. It came with loos hardware, difficult to trouble shoot when you expect it to work right out of the box. The algorithm that sets to auto mode is too cold (and slow). When the welder flashes to start, It jumps the voltage to high to (start the arc) and it melts the wire back and jams the gun. When the gun jams, the feed mechanism forces the wire through the rollers and bends it. If you set the roller tension too light (to try to avoid this), it doesn't push wire into the weld puddle well. I'm a seasoned welder and this has to be the worst machine I've ever used. I've waisted so much time trying to make it work. Don't buy this thing until they make significant improvements. Even in the video, it shows a cold clumpy weld. It was a waist of money.

unboxed machine set up as per directions power comes on but doesnt work to feed wire through torch

Item arrived damaged, looks like used, not in proper packaging, ground cable has signed of being used,

Zelfs op de hoogste instellingen wil het nauwelijks penetreren in dun blik, je krijgt geen hitte in het materiaal. Ziet er verder wel leuk uit maar hij is niet te gebruiken.

Nie niesom spokojny.zvaracka je dobra ano to musim uznať.ale drat ktory bol v zvaracke nieje vhodny do tej zvaracky.takze som si musel kupit novy drat ktoty ma vysiel skoro na 39 z postovnym.inac vsetko super.

Saldatrice per obbistica

Tester 15 minutes en mode gaz. Les premières soudures faisaient des billes d’acier non adhérentes. Puis au bout d’un certains temps le poste m’a disjoncté ma protection dans le tableau électrique. Après plusieurs essais, en débranchant tout, en laissant le poste débrancher un we, cela ne change rien. Ça me provoque toujours un court circuit. Vevor négocie pour que je ne renvoi pas le poste en me proposant la moitié du prix d’achat. De l’argent jeté par la fenêtre. Passez votre tour.

Welder do not provide the possibilty to adjust wire feed speed. Welder have a programed soft start feature for the wire speed and you can't remove it. Gas hose is cheap and do not come with a regulator so dont think about gas welding straight out the box. Do not think it's a great welder for over 1/16 thick material. The overall welder quality seem ok. Instruction that came with the welder are the basics and cover the minimal.