Reseñas de clientes para VEVOR Portabicicletas de Piso Longitud de 283,5 cm Portabicicletas de Acero Capacidad para 9 Bicicletas Estante de Almacenamiento de Un Solo Lado para Garajes, Calles, Patios, Eventos de Ciclismo

No son del material más pesado, pero combinan ambas funciones fácilmente y por el precio que tienen son imbatibles.

I bought this for a nonprofit center so patrons could park their bikes safely. They had been chaining bikes to the gas meter, not so safe. It was easy to assemble, good quality, had all its fasteners and easy instructions. Everything I've ever bought from Vevor was well engineered and was a one person assembly.

VEVOR 10 Holders Floor Bike Rack, 59" Length All-Steel Grid Bike Rack, 10-Bike Capacity Dual-Side Storage Stand for Garages Streets Yards Bike Events Unit is as described and arrived on time. Good Price and Quick shipping.

If it wasn't for the lack of instructions, I would rate it higher. I had to figure out the assembly by looking at pictures of the product assembled online in order to put it together.

Very good quality. Works as expected.

a bit on the flimsy side. seems like it will quickly rust. saying that, the price is right, i would still recomend.

Came very fast. Unfortunatly it is horrible junk. Held together with screws. Most certainly not secure to lock a bike to. I dont recommend this at all.

It will do the job but it is not very sturdy or well built for the high price of it. Disappointed to say the least

el producto esta bien no ay queja, pero claro si confian en transporte a seur que mienten para no traertelo a casa por que pesa ay perdemos todo. confien en tranportes buenos y le ira mejor

This is a good light duty rack. I am not sure how well it would stand up to the outdoors. I have installed three and may buy more for an indoor bike room. The instructions were a bit clumsy to use but the picture shows the position of all the components and it went together fairly easily. Was supposed to come with a wrench but instead there was a useless tape measure. It came with a tiny philips screwdriver but too small to apply any kind of torque. Have a decent philips with a small tip. A deep 10mm socket on a ratchet wrench or a 10 mm nut driver or a box wrench is necessary. As I said no wrench was included as anticipated. Also the end caps to keep water etc out of the pipes do not go in by hand. A hammer, either with a steel peen or urethane mallet are needed. There are small washers that go under the nuts. Washers that held the nut as you tighten the screws would have been a lot easier. Also, one of the pipes were dented making it unable to be joined to the next. Fortunately we had a plier that allowed us the pull the dent out. So, phillips, 10mm wrench, pliers and hammer are necessary. If we need one or two more, I have no hesitancy getting these identical units.