Reseñas de clientes para VEVOR Pinzas de Herrero de Acero al Carbono Pinzas de Forja Duraderas Forma de V 46 cm Mango Largo Buen Agarre Operación Segura Equipo de Herrería para Pernos Forjados en Forma de T y de Cabeza Ancha

so I have now had a bit of time to use these tong. although I knew they would be useful, I was quite surprised at the quality of them. they are beefy and strong. hold my work well. I am rather inpressed with that and very glad I bought them. when I bought them it came out to about $18 a tong. I can't make them for that much once you add up the cost of the metal and gas. the only thing I wish is that they also offered these tongs on other sizes as well.

These tongs are well made and are very sturdy. I have used them for a month now and still look like they are brand new. I would recommend them.

I purchased this set of tongs because frankly, I can't make them for this cost. So far I have been pleasantly surprised. Recently making a set of hatchets I found the hammer eye tong to be particularly useful. The tongue rings and have a ball at the end to allow using tong clamps to hold them shut. On square stock the v bit songs have a good grip. The reins are beefy.

Correcte

The tongs are pretty good. They are a bit on the heavy side but they get the job done. Now that I have some I can make my own custom ones.

solid and cheap tongs. I needed to do some small adjustments to the tongs to fit my use, but these are great for beginner blacksmiths.

Little awkward to use. Probably has a lot to do with my hands on experience. Will probably do a little modification to one of them.

Not to bad. They are a bit heavier than my old hand made tongs. They do take some adjustments to hold tight. As sold they have as limited range where they're "happy". But over all a good product and I'd recommend. Chuck. Mýri Afla* *Swamp Forge

the reins will need a little modifying and though I have seen far worse they could be made to work, the reins will need a little modifying and though I have seen far worse they could be made to work, the reins will need a little modifying and though I have seen far worse they could be made to work, the reins will need a little modifying and though I have seen far worse they could be made to work,

The tong handles are made nice, the wolf jaw are best - the v bit is a little to large for what I’m using it for, but it works! Haven’t tried the Zv’s yet, but confident it’ll do just fine