Reseñas de clientes para VEVOR Pinzas de Herrero de Acero al Carbono Pinzas de Forja Duraderas punta en ZV 46 cm Mango Largo Buen Agarre Operación Segura Equipo de Herrería para Hojas de Cuchillo Piezas Largas y Circulares

so I have now had a bit of time to use these tong. although I knew they would be useful, I was quite surprised at the quality of them. they are beefy and strong. hold my work well. I am rather inpressed with that and very glad I bought them. when I bought them it came out to about $18 a tong. I can't make them for that much once you add up the cost of the metal and gas. the only thing I wish is that they also offered these tongs on other sizes as well.

These tongs are well made and are very sturdy. I have used them for a month now and still look like they are brand new. I would recommend them.

I purchased this set of tongs because frankly, I can't make them for this cost. So far I have been pleasantly surprised. Recently making a set of hatchets I found the hammer eye tong to be particularly useful. The tongue rings and have a ball at the end to allow using tong clamps to hold them shut. On square stock the v bit songs have a good grip. The reins are beefy.

Correcte

The tongs are pretty good. They are a bit on the heavy side but they get the job done. Now that I have some I can make my own custom ones.

solid and cheap tongs. I needed to do some small adjustments to the tongs to fit my use, but these are great for beginner blacksmiths.

Little awkward to use. Probably has a lot to do with my hands on experience. Will probably do a little modification to one of them.

Not to bad. They are a bit heavier than my old hand made tongs. They do take some adjustments to hold tight. As sold they have as limited range where they're "happy". But over all a good product and I'd recommend. Chuck. Mýri Afla* *Swamp Forge

the reins will need a little modifying and though I have seen far worse they could be made to work, the reins will need a little modifying and though I have seen far worse they could be made to work, the reins will need a little modifying and though I have seen far worse they could be made to work, the reins will need a little modifying and though I have seen far worse they could be made to work,

The tong handles are made nice, the wolf jaw are best - the v bit is a little to large for what I’m using it for, but it works! Haven’t tried the Zv’s yet, but confident it’ll do just fine