Reseñas de clientes para VEVOR Abrazadera de Horquillas de Tractor Longitud de 149cm Abrazadera en Horquillas de Paletas Carga de 1814 kg Cargador Frontal de Accesorios para Tractor Cargador de Cuchara para Agricultura Granja

Good product for the price and they work well. Only complaint is they do slide around your tractor bucket and don’t stay straight even when secured well.

Overall, product seemed to be a good product until however, I found the hardware used to tighten the forks to the bucket inferior because the "flange nut" intended to hold the forks firmly simply stops turning when it touches the buckets edge and the threaded rod it's attached to only applies pressure over a very small area and doesn't keep the forks from rotating out of alignment. In addition the crossbar intended to also help keep the forks from moving sideways is only held tight by a wingnut too small to tighten sufficiently to keep bar and forks alligned. I purchased this product to assist in picking up small limbs and branches around yard but proved to be insufficiently capable of staying aligned thus too much trouble without actually welding the forks to the crossbar.

attache sur les bras de relevage trop courte, attache des fourche trop fragile

If I had it to do all over I would bought the ones that are connected but I just welded a piece of pipe to mine. They serve there purpose but the will shift one you no matter how tight you get them.

Quality of steel forks are really good but the center likes to pop out sometimes. If they made the center a little more steady it would be pretty good product.

Get what you pay for within a couple days the paint on the forks flaked off peeled off. Tighteners are difficult to work with. If you can afford it by high-end.

Die Gabel selbst hält die 1000kg vielleicht aus aber nicht die CAT1/CAT2 Bolzen. Habe damit ca. 400kg gehoben und die Bolzen sind verbogen.

I found the forks absolutely useless and a complete waste of money!!! First, I had to file the divider down to fit it over the forks. Second, When I tightened the bolt to keep the divider at a constant width, it snapped quite easterly and Third, The forks wouldn't stay tight on the FEL bucket, it didn't matter how tight I initially tightened them. Typical CHINESE RUBBISH, I should have known better. I would be VERY hesitant to buy anything from Vevor again.

They are a little flimsy but work ok for what I need to do.

They are a pain in the A## to use, always slipping, even with a plate under the hold down area, they bent my bucket. I will be welding them permanently to a plate