Reseñas de clientes para VEVOR Motosierra de Gasolina de 305 mm, Motosierra de Gasolina de 25 cc, 1,02 HP con Mango Antideslizante, Doble Depósito de Combustible, Ideal para Cortar Madera, Podar Árboles y Limpiar Terrenos

1st pull of the rope the spring broke. They sent a new rope. 2 nd time it cranked the motor seized. Junk junk junk. Heck no I wouldn’t recommend and I knew better.

Was using it and started idling high and then wouldn't start. After taking it apart, found air filter crushed in housing, mounting nut not connected, saw dust in carburetor. Cleaned out carburetor, was able to get filter bent back to somewhat working condition and now saw works. All I got from Vevor support was some automated messages on how to get it unflooded. Not even a free filter to replace the one sent crushed. By the way,this saw is very loud compared to my other saws.

Only used it a couple times, now it won’t start and support is a joke. They want a video for an already known problem.

Couldn’t get it started for days. Finally my son came over. We got it started and it started leaking gas soaking the bottom of the handle and dripping to the ground.. unfortunately the unit must be defective and knee replacement

The gas tank has a hole in the side of it. The company takes at least 2 days to return messages. They are sending a new gas tank that I have to install. Less than a month old. There is no customer service phone support. After 2 different messages with pictures stating the gas tank has a hole, they stated they would send a new bar oil reserve tank. Again took 2 more messages to get them to send a new fuel tank.

Pulled it twice pull start broke fixed same problem.unable to use it

Bought this saw in September and open box on 1 / 11 / 26 chain saw not what the video shows. I would not recommend this saw for any project.

Recoil spring broke after 2 pulls. Did not even use the saw

Le pot d'échappement a brulé les plastiques carter frein de chaîne et carter pot d'échappement⚠️ : sur du bois sec. Je ne peux pas mettre de photos et vidéo dans la case "Mettre des images"

The saw starts easily when cold and runs well. However, if I stop it and let it sit for a few minutes while still warm, it will not start again. I have to wait a long time for it to cool down completely before it will start. This is very frustrating in practical use, as it causes unnecessary downtime and makes the saw unreliable for continuous work.