Reseñas de clientes para VEVOR Soporte de Rueda de Motocicleta Capacidad de 816,5 kg Calzo de Rueda Diámetro de 381-533,4 mm Ancho de 76,2-165,1 mm Soporte de Transporte de Acero para Remolque Taller Garaje

This wheel chock is of good build quality. There were no instructions included and the hardware was loose in the box. I had to scrounge for nuts bolts pins and washers. I did go together without instructions so maybe not needed. I did not have problems in assembly. I did have to place a thin piece of wood just before and just after the rotating wheel holder to accommodate the weight of a touring Harley Davidson (900+/- lbs.) All in all, I'm satisfied; its stable and it feels secure even without strapping it down. However, safety first!

Bon matériel assez lourd donc assez robuste, par contre dommage que le réglage ne se fasse pas sur la cale arrière.

I had to make two alterations to make this usable. I didn’t want to bolt it to the floor so I fixed a 600 mm long piece of 40 x 40 steel angle to the front. Some rubber strips under this stopped it sliding around and makes the whole thing very stable. With the bike in the stand, the shiny plastic coating on the base allows the tyre to ‘squirm’ sideways a lot and the bike is not held upright with any security at all. I overcame this by bolting two short 50x40 timber sections to the base in close contact to either side of the tyre wall. The tyre can’t move sideways and the bike stays vertical. Both these mods could be done by Vevor!

Round head bolts not ideal for the thickness of the metal, the square hole turned round on hand tightening, instead should have a standard bolt head so can be held in place with a tool.

Krever modifisering før bruk. Begge platene er "slarkete" når framhjulet er på plass slik at sykkelen ikkje står stødig og risikerer å velte (Yamaha XMAX 300). Ved å borre nye hull i framplaten for å skru denne fast samt sette på ekstra skiver blei det bedre. Sjølve konstruksjonen er av god solid kvalitet og veier 17 kilo.

Vevor claimed would work on my 2026 Indian scout bobber. Useless with my bike

I put my tent garage up and was very happy. I also made a stone foundation to anchor it well. After one week it was a windy weekend and the complete tent went to pieces. Too bad because the idea is brilliant.

Harley Davidson mit 21" Voderrad geht leider nicht!!! Musste ein neues Loch bohren und jetzt passt es

One of the pins need to be pounded in and out with hammer. (Holes aren't lined up properly) Not great for on the fly adjustments as tools are required to do so.

Description says fit wheels up to 21 inches, but it doesn't. I tried all of the different settings on the wheel chock but the bike keeps wanting to fall.