Reseñas de clientes para VEVOR - Martillo para hinca de postes en T a gasolina de 52 cc, motor de 2 tiempos, martillo para hinca de postes portátil de 1400 W con cabezal para hinca de 3 postes (49/69/100 mm), para cercas de granjas y ranchos, mejoras de carreteras

It worked great on the test posts we did but after winter and we pulled it back out of the box and put gas in it, it wouldn't start. Figured out the carborator wasn't letting gas into the engine. Purchased a carb and waiting on it to show up

Couldn’t drive a 3 5/16 post more than 2” into soft ground. Very disappointed

Didn't fit on a wooden 4x4 as advertised

Frustrated 😫 with this machine's lack of power, and the vibration keeps loosening most of the cap screws. The hammer mechanism bolts all came loose without much stress on the machine. I was driving a wood post for a fence, and it has been frustrating having to stop frequently to tighten bolts and screws so they don't go flying all over the place.

I have bought a lot of equipment from Vevor, but sadly I have to say I was disappointed with post driver. I have used several over the years, but there was one significant issue that I couldn’t get over. The collar that the driver sat on just isn’t long enough. I was trying to drive 6.5’ t-posts and the head of each post bottomed out about a 1/2” in which causes the heavy machine to be very unstable making it difficult to drive the t-posts in straight or even support it. It was literally more exhausting trying to support it than just using a manual post driver. The quality was decent and maybe a round 4x4 post might be better since it has a large flat head to rest on. It comes with different size collars to support different types of posts, so I am going to try using a larger collar with a piece of steel tube the t-post can sit in to give it more stability.

Post driver was a big disappointment. It couldn't even drive one T-post. Seller refunded and had good communication.

I was pleasantly surprised at how nice the case was that came with the pounder and all the accessories. I put a mixed fuel in and it fired up with about the right amount of pulls that I expected. The issue I ran into was that the posts I was pounding seemed to take much linger than I was expecting. I would say that it took longer than when I pound with a manual post pounder. This leaves me very disappointed because I have dozens of these posts that need to be planted in the ground over the next while and I was looking forward to being able to easily put the corner posts in and become more efficient but unfortunately that has not been my experience.

You get what you pay for. There is not enough power to sink post in even soft ground

I bought this as a back up to my titan PGD 3825, which is getting old, for drill pipe. This product is not strong enough, and the machine smocks sometimes. I created a ticket on 04/18, and I am getting the run around to return this machine. All I need to do is return this and get a machine that works. If they have a better one this works, I can exchange . After sending 3 emails fasting for a return label, this morning I got an email with a video on hoe to warm up the engine. How does that help in this situation

This broke after using it on 10 wooden posts 1.5" square being driven into dirt. Think about that, the metal driver broke in half trying to hammer a soft material into a softer material. I emailed for a warranty replacement assuming it was just some kind of production defect. Took 3 days to get the first response. Now, after 11 days of very slow back and forth with " customer service" I'm so fed up with this whole mess that I don't even want a replacement tool and I won't be dealing with vevor again.