Reseñas de clientes para VEVOR - Martillo para hinca de postes en T a gasolina de 37,77 cc, motor de 4 tiempos, martillo para hincar postes de cercas a gasolina, con cabezal para hincar 3 postes (45/55/88 mm), martillo para hincar postes portátil de 1000 W para cercas de granjas y ranchos, mejoras de carreteras

The service was fast, but the machine has not been used yet... Weather too Hot!!!

I used it to pound 15 fence post in the ground and had to tighten and put lock tight on then. Otherwise I love the machine

For the price of renting, you buy one. Works great!

Good product. Easy use. Arrived with transport box broken during transportation. No new parts supplied after weeks of discussion - compensation instead. Customer service again.

Product performs as describes. It is heavy, but that is the reason it performs!

One of the best investments you can make, if you have post fences. I had to put in a total of 60 post, both pipe and tbar. 2 hours, 1.5 tanks of fuel. Worth every penny.

Easy to set up and use. Used to install poles for a chain link fence and also used on putting in dock poles. Works at it should, no issues for the last 3 projects over the last 9 months.

We were about to give up trying to get this to drive a t-post and had even reached out to return it. We found a youtube video that gave us some tips on what to do. You will need to let the post driver warm up for 5 minutes then set it on half choke and leave it there. Then when driving the post you don't want to go full throttle. Works like a xharm and seems to get better every time we use it. Of course it's not going to drive through rock but it does work great for the price. Very happy with this purchase!

This tool saved me many hours of work, and I really could not have done this job without the post driver. I used it to drive 2x6 boards into the ground in front of a lake wall to seal the areas undercut by the lake eroding the soil under the original wall. I tried driving these boards in using a sledge hammer into a heavy clay soil (lake bottom) and was only able to get 8" deep. The post driver was able to get to an average depth of 15 inches. I made an adapter (on 2nd board from right in the picture) to connect the driver to the boards. Like other have noted, using the low speed, just a bit above idle worked best. And when it reaches a point where no further progress can be made, stop to avoid breaking the tool or your work. It is slow but steady. Super easy starting.

Excellent product…we will continue to support VEVOR and its products especially if their products remain top notch!