Reseñas de clientes para VEVOR Máquina Pelacables Automática de Hierro Fundido 1500 W Pelacables Eléctrico Motorizado de 1,5-40 mm Pelacables de 27 m/min con Manivela Manual Extra 9 Canales para Reciclaje de Chatarra de Cobre

Excelente máquina recomendo, bastante boa.... Já vendi e vou querer mais. 😁😁😁😁

Awesome machine!!! Strips wire like an animal lol Would definitely recommend this product to anyone looking to process a lot of wire

Sehr empfehlenswert, würde ich wieder kaufen , sehr stabil, super Preis, gute und schnelle Lieferung.

Good machine. Runs smooth and has plenty of power to pull any wire through. A small learning curve in getting the hang of it when you start out. If you go too tight on the blade pressure it can kick the wire off to the side leaving the wire untouched. Buy it. TRUMP WON!!!!!!!!!!

Works great, didn’t think it would be all that good but I’m impressed with it, only problem I had lever came in broke to manually operate and I’m waiting on a response back from the department, but other then that it is amazing does exactly as described!!!amazing

Bonne machine, vas bien ! Je recommande pour des travaux personnels, pas nécessairement pour un usage commercial

This machine is awesome it does exactly what this claimed. Once you dial in the settings it works dream, I very happy with my purchase.

Absolutely love it works great and it pretty dam quiet so over all happy I can put up with stripping wire now

Einfach zu bedienen funktioniert einwandfrei! Leichte Inbetriebnahme, schnelle Lieferung einfach und ohne Probleme!

I recently picked up a bunch of smaller-gauge wires, 16 and 18 mostly. They were in pieces both long and short. Since I also have a foundry I try to hang on to stuff like that and use it in casting. But using my manual wire strippers was incredibly time-consuming, and honestly really hurt my fingers after a while. I saw this machine, that is was really affordable and adjustable as well, so I took a chance and bought it. Vevor is great about shipping things out pretty quick, and in no time I had it in my hands. It literally took seconds to set up and adjust to get the right cut for the wire gauge I was stripping. In minutes I stripped a whole pile of wire that would have taken me a dozen hours over evenings (this is a hobby for me, not a job). With the jackets split all the way down the center, it was easy to peel away and get the copper from inside. Mine was almost exclusively stranded wire. When the jacket stuck to the wire too much, I'd just run it through the machine again on the other side. With two long-axis cuts on the jacked, they came off easily. Highly recommended, smooth action on the handle. One night with this saved me a week or more of work!