Reseñas de clientes para VEVOR Máquina Dobladora de Chapa Portátil de 1220 mm con Ángulo de 0 a 135° Dobladora de Metal para Acero con Bajo Contenido de Carbono de Calibre 20 y Aluminio de Calibre 14 para Doblar Metal

Great little box pan break. Highly recommend Requiring 100 characters min for a review is stupid however

Good product. Good item that gets your job done. The folding arm is stiff and hard to handle. It's probably a good thing as there is no play. Over all its easy to adjust and does a good job. Delivery was relatively fast, although it doesn't reflect the dream delivery times presented on the website. Considering the price, it is a great tool for a startup or hobby shop.

Best thing since sliced bread. Easy to use and precice. Even my grand mother can use it. I highly recomend this item . Buy it. Buy it now . Buy one gor ya mother.

Tool came in a wooden crate ensuring a safe delivery. After initial adjustments it works great for my uses. Of

the Brake is a great investment for my shop, work great for what i need it for, thank you for the great prices

the great tool is well made it does the job, very positive these days as often items don't work as promised this one simply does the job well. Great work

The overall build and usability of the bending brake is quite good. It is quite heavy and suited for the job. The edges on the base, knife and anvil are all straight and sharp. There are just a few minor craftsmanship and and quality control issues. The first is the handle on the left side does not fit. The shaft on the handle is 9.8 mm, but the hole into which it must fit is only 9.6 mm. While this is easily remedied with a 3/8" HSS drill bit, it should be necessary. The right side fits just fine. The set screw for the knife depth on the left side was almost all the way out. Again, this seems like a minor and easily remedied issue, but it is likely the reason the angle bracket holding the screw on that side is ever so slightly bent. This probably occurred in shipping, but would not have happened if the set screw had been set flush. There is also signs of rusting at this corner, which are apparent at various places on the entire tool. This was present when the tool arrive, and it has been stored in a controlled environment since then. Again, minor and easily remedied. Again, it shouldn't be necessary. And finally, the instructions specify the bending brake should be fastened to the bench with 3/8" bolts. The holes in the base are too small for that. You will need to either use a slightly smaller bolt or drill out the holes to match. None of these issues are show stoppers, and I still highly recommend the tool.

Seems to work well for what I bought it for. Unfortunately, it had weld slag in some holes that I had to remove before using.

Heavy steel fabricated. Most breaks are aluminum I have used in the past. The wing nuts locking mechanism is a little awkward to use, again not what I am used to. It only bends to 60 degrees, so you cannot "hem" with it. It served its purpose.

parfait