Reseñas de clientes para VEVOR Máquina para Hacer Insignias de 25/32/58 mm Prensa para Insignias con 300 Kits de Consumibles y Libro Magic Panda Máquina para Hacer Insignias de Alta Resistencia para Hacer Insignias, Azul

Pretty good but most would not work

Les supports en metal sont oxydés....cf photos Sinon une fois qu'on a pris le coup ça va bien a utiliser , penser a mettre la rondelle noire dans le support pour les support métallique et a la retirer pour les supports plastiques

I received 3 inch pins instead of 2.28 inch pins. But what else can i do. They are good tho.

Loved it until today... Purchased as a present in March; started using it in April. Have made roughly 200 buttons before the plastic handle snapped, right at the pivot point. Will likely replace with a metal-armed one. Hope that there is some manner of warranty available still. 🤞 Update: I am downgrading my review to 1 star, based on the shockingly bad level of customer service. The company reached out to me after seeing my poor review and offered a couple of options (small partial refund or part replacement). I responded to their email and have received no manner of action or reply since, despite a further follow up to them. Very disappointing and I am now debating whether I will return my newly purchased replacement unit, solely on principle.

Mala calidad, deja de funcionar a la tercera vez que la usas

Doesn’t work!

Extrêmement déçu, le bien reçu ne correspond pas au bien commandé. Malgré une demande immédiate de renvoi du bien reçu et la demande de livraison de celui commandé, aucune réponse 3 jours après la demande. Cela est inadmissible et non professionnel.

Machine is not very robust, but that should be okay. However, the magnets come out loose, mylar only sticks in the corner, so it is not working properly. I tried to contact support, but they are nog answering my emails. Feels like I threw away my money...

Works well except for the 25mm badges which pretty much fail with every attempt. The unit did seize up once when crimping as well, took quite an effort to get it open again.

A gép, nem illeszkedik egymáshoz , ezáltal a használata során megcsuszik a kép és ferde lesz a végtermék. Au első lépéseknek nagyon nehezen lehet lenyomni , és olyan hangja van mintha el akarná törni. A kép alján látható a szöveg " rossz élet " jobbra leejt . Csináltam vagy 20 db mágnest különböző technikákkal de mindegyik minimálisan ferde , és ez akkor keletkezik mikor össze préselem az első lépést. Nekem sajnos pici csalódás volt