Reseñas de clientes para VEVOR Kit de Reparación de Bujías Incandescentes, con Malla Atomizadora, para Calentadores de Estacionamiento 5 kW/8 kW, para Conducir en Invierno o Acampar en Entornos Fríos, 12 x 12 x 250 mm

This kit was purchased to repair a 2Kw heater. The kit was specified per the Vevor information on line to fit 2 / 5 / 8Kw heaters. It does not, the gaskets are for the 8Kw, I don't know if they fit the 5Kw, but they absolutely DO NOT fit the 2Kw. The basket and ignitors seem to be all the same so only 1/2 the kit was wrong. VEVOR made it right with me so I have no complaints . Overall I am very happy with Vevor products and service.

Alles gut geklappt

The spare parts arrived on time , as desribed and in good order. However the included gaskets were of the wrong size for my heater. After contacting Vevor about this problem the issue was settled promptly to the satisfaction of all and a refund was promptly made. I have great faith in this seller for their prompt action and honesty. I would use them again.

Ideal for a maintenance, used diesel heater everyday for almost 2 years now, and used a new seal from this maintenance set. Better seals than the original on the dieselheater.!!!

Product is heel goed , zeker prijs kwaliteit verhouding, Alleen jammer ( heeft niets met Vevor te maken ) dat de Bode GLS een onbetrouwbare bezorger is . Zelf achter je pakket aan en ophalen bij het centrale-magazijn of via een ander erachter komen dat het op een ander afhaal-punt is geleverd .. pffff zo jammer

Ottimo prodotto..ricambi perfetti.. consiglio..

The kit was well priced and had everything you would need in it. It came wirh the screen, which I did not need, but figured I would replace it anyway. I had only ran my heater about two months and maybe 50 gallons of #2 Diesel through it when the glow plug failed. In regards to the screen, unless you need to change it, I wouldn't otherwise. Mine came out really hard using a wood screw threaded in to it, which should have clued me in in hiw bas the new one was going to be to install. The screen fits really tight and it being a screen you reall can't just hammer it in, you would obviously damage the screen if you did so. I rolled it on a table top with the idea of it working itself in to a bit smaller in diameter. I then took a nail that fit inside the screen and cut it to be a little under flush than the end, like 1/32". I used they to very carefully and slowly work the screen down in to the hole. I was actually quite surprised that I was able to get it back in and that it worked. I would definitely just use sime type of spray cleaner and air to clean the screen should i ever suspect it was dirty versus going through that again. I would recommend the kit to anyone who needed one based on the reasonable price and it containing everything you would need.

Just for spare, looking well .

Just spare.

Identique aux pièces d'origines, qualité identique à première vu. Avoir sur le long terme