Reseñas de clientes para VEVOR Kit de Dirección Hidráulica Fueraborda 150 HP Sistema de Dirección Hidráulica Marina Cilindro de Bloqueo Bidireccional Manguera de 7,3 m para Barcos de Un Solo Motor de Una Sola Estación

Explication de montage des différents raccords,pas assez précis. J ai eu plusieurs doutes lors du montage, préciser aussi la possibilité de changer de côté la purge sur les T Joindre dans votre colis 1 bidon d huile hydraulique.

De bonne qualité mais fuite à l installation

The sistem is solid. Just instaled before few days.Problem is leaking oil from cylinder semerings(seals) and orings from back side on the helm pump.

Bon produit, facile à installer

Just had it installed a week ago. Took it on a test float. A far cry from what I had previously - cables and pulleys. Made it out of and into a marina well one-handed! 26 foot pontoon with a 150 Merc. I'd go 5 stars across the board but I've only tried it out for a couple hours. The boat is leisure and fishing/trolling on a very big lake in Michigan. This was a quarter of the cost for a SeaStar system! If I get 5 years out of this I will be a very happy consumer! I'll also add that the marina owner told me how easy it was to replace/install, and the helm replacement was very straight forward. He's hooked too, so I'll be asking him in a month or so how he likes his. He does lots of boat maintenance, and if's he's happy, Vevor will be doing a lot more business.

Hyvin toimiva hydrauliohjaus kohtuu hintaan.👌

Bonjour Pouvez-vous m'envoyer la notice de montage en français ?

Purchased the one for a 75hp which is what my motor is however at speed it would not turn the motor. This one works fine hard to bleed air out. Still have a delay in the steering but it will hold a strait line now

Bonjour Je ne retrouve pas les factures sur mon compte, pouvez vous m'envoyer la facture associée à cette commande ou me dire ou la trouver merci Cordialement sylvain@nautiroise.fr

I've this on the boat for about 100 hours. The boat is used in salt water but trailered and not kept on the water. It's worked flawlessly so far. Install was straightforward. No signs of corrosion on the hydraulic cylinders at the engine, but the helm has quite a bit. Salt has penetrated the powder coat and has began the typical bubbling on the metal. The boat is rinsed after use and Salt Away is used every few uses, which leads me to believe there were flaws in the coating that allowed salt in. For the cost, it is what it is... Better coating would make this an unbeatable value.