Reseñas de clientes para VEVOR Juego de Machos y Terrajas 40 Piezas Tamaño SAE NC/NF/NPT Kit de Machos y Troqueles con Maletín de Transporte Portátil Accesorios Completos para Construcción Reparación de Automóvil Fontanería

Always using a tap or die. Bought because it was cheap. On opening it for the first time pieces fall right out and don't stay put. Only used once on a 1/4 20. No drill bit guide included. Good if your into cheap

I gave my ratings on this set based on receiving and viewing this set, I haven't physically used it yet, though if and when I do, I hope I can change my opinion.

Half the taps and dies Don't work due to the machining of them being very poor, m10x1.5 die doesn't even fit a m10x1.5 thread and noticed a bunch of them are juat poorly machined and don't work

A good range set for the money, if your a occasional user. The worst thing about it is the cheap plastic case. It doesn't hold the dies nor a good deal of the taps, so closing and opening is fraught with pieces flying all over the place. The tool handles are also cheap and loose their grip easily on the taps. Address those 2 shortcomings and it would score better

Does the job i needed it for

I just received this tap/die set. The taps are absolute junk with huge burrs on the leading edge of the flutes. If used, these taps would destroy a threaded hole. I didn’t expect real tool quality but expected that the taps would chase a thread. Do not buy these as they are by far the cheapest of the cheap.

Not good damaged thread on first die used and small screwdriver with the set was bent like a banana. Photo's will not upload from my phone.

Ive bought several tools from vevor over the last 3 years or so almost all of them have done exactly what i bought them for....the tap and die set not so much. First tap i used snapped off 3rd turn trying to cut threads into mild steel and took an hour to get it out. Tryed to use several die and they dont even clean up the threads already there. Completely destroyed a wheel stud trying to clean threads up. Will definately not buy again.

I did residence this tools, but I have not used this jet.

This item is not worth the money, don't buy their description of high-grade HRC55-62 hardened bearing steel, effortlessly handling heavy loads and high pressures, I tried to cut some threads on 3/16" rod and it would not cut them. I had used a tap & die set from Harbor Freight to cut the same size threads on the same rod about 2 months ago and it worked way better than this set from Vevor. I should have borrowed that die set again instead of buying my own