Reseñas de clientes para VEVOR Juego de Extractores de Cojinetes para Agujeros Ciegos, 16 en 1, Kit de Extracción de Juntas y Pistas de Cojinetes Internos, Martillo Deslizante, Inserto Piloto, con 10 Pinzas Divididas

The small pillars have an extremely difficult time grabbing a hold of a bearing to actually pull it out of place plus the option of what they give you to support. The pole is good in certain applications and very, very bad and other applications in which case you will actually have to find some sort of pipe or something to compensate for the pool device that you’re looking for the smaller, the pillar, the worse that it works, the larger the puller the better that it works, the second smallest puller after two uses was already destroyed

After many improvised attempts to remove a bearing from my free hub this tool did it in about 30 seconds. Easy to use. The tools were oily, and the case was not great, but they were very functional.

Advertised as capable of 1/4" bore up to 2"+. Not true. The bore into which I needed to use the tool to extract a bushing was too large for one of the tools, and too small for the next size tool. In other words, the adjustment available from one tool to the next does not cover all possible bore sizes between 1/4" and 2"+ as advertised. I had to grind the oversize tool to fit in the bore where I needed it. Quality is what you would expect for Chinese made tooling; adequate if you don't need precision or intend to use the tool often. Still, after modifying one of the pullers it got the job done.

Des sa réception j'ai essayé d'extraire un roulement dans succès, le premier embout est carrément foiré.. La qualité n'est pas du tout au rendez vous

Could not pull the bearings from a Chevy 14 bolt with this tool it might work on smaller units. Went to a rod throught the housing like old days. Slide hammer would need to be bigger for what I tried to do.

Solo pedí uno me hicieron el lío y al final me cobraron 2 el producto bien , gestión por parte de vevor fatal

Me an mandado 2 y yo solo pedí 1

I used the tool one time and after a few hits it’s pushed the t handle off the end. All threads were stripped out. Other than that. Would be a good tool.

Aún no lo e recibido