Reseñas de clientes para VEVOR Horno de Fusión de Propano Kit de Horno de Fusión de Metales a Gas 8 kg Horno de Fundición para Hogar con Crisoles y Pinzas, Mango de Madera para Reciclaje de Aluminio, Cobre, Plata, Oro

will not get hot enough to melt copper much less gold or silver

couldn't get copper to melt. it would soften to nearly liquid but never get all the way. im not happy and I wouldn't recommend anyone buy it.

The hose has a pin prick type leak in it almost immediately after buying it and nothing should’ve caused this.

So before you guys even purchase this acknowledge the fact that you have to go out of your way get the refactoring cement and you have to apply this to that ceramic mat. Also I'm not sure it is actually made for the temperatures it can actually reach. The reason I say this is the top start to melt and turn into a bowl versus a lid. The overall device is all right but they used some s***** I mean crappy metal for the vessel. I may actually have to send this thing back because I don't want the vessel to up and fail on me when I've got gas flowing. Not to mention two lines generally means you may want to get a larger tank.

Habe den Schmelzofen nicht erhalten,Obwohl er ein zweites mal geliefert werden sollte das von ihrer seite ???? . Lieferung und Bearbeitung 10 Sterne Minuspunkte. Gruß P.Evers

Decent burner, thin shell, only an unhardened layer of some version of ceramic wool for insulation. My home built unit cost less and is better built than this. Not sure I trust it to melt brass.

Ordered this to replace my Vevor 6kg furnace. When it got here I realized is was the same size furnace with a bigger crucible and less insulation. The only differences were that it was stainless instead of plain steel and had two small burners instead of one big one. The worst part was that I argued with VEVOR for over a week about taking it back even though I was paying for shipping. The finally gave me $100.00 to keep it and I sold it on FB to recover the rest.

It’s really easy to use but the length and temperature is not accurate. I must have had it running with both propane furnaces open for around an hour and it never got hot enough to melt aluminum. I eventually just turned it off because I didn’t want to blow through a perfectly good propane tank. I tried again on another day for 30 minutes and still only turned the aluminum to ash. Disappointed. Melts pewter super fast but so does a heat gun lol.

I can’t get mine to melt anything, may try aluminum but I’m not holding my breath. Going to try it with oxy/acetylene rose bud but that’s a cost I was trying to avoid. Price would be good if it worked

Charged to 100%, tried to start my F350, it did absolutely nothing. I drug out my old jump pack and the old one worked just fine. Normally Vevor knocks it out of the park, not so much with this.