Reseñas de clientes para VEVOR Herramienta de Alineación de Ruedas, 2 Piezas, Placas de Medición de Convergencia de Acero al Carbono de Alto Rendimiento con 2 Cintas Métricas, Compatibles con Automóviles, Camiones, SUV

Well built from heavier stock than I expected and longer size works good for more accurate settings. It's well worth the price

Bon produit dommage qu’il ne soit pas fourni avec des cales pour éviter de bloquer dans les étriers

Fast alles super, Top Qualität, schnelle Lieferung, einfache Handhabung nur ein kleiner verbesserungs Vorschlag, auf dem Bandmaß könnte die Skala auch in cm sein. 🤔 Bin sehr zufrieden und würde es auch wieder kaufen.

bon matériel difficile a utiliser sans fosse

Could stand to be a bit thicker gauge, but they definitely make alignments easier. Tape measures are cheap garbage but they function for now.

Made setting the tow easy but was a fail on camber and castor on my 1969 dodge Dart. The factory wheels sit too far in so the tool interferes at the fender.

I have used this alignment tool to adjust toe-in on 3 vehicles. On my Suzuki wagon 2whl drive, Hyundai sedan 2wd it worked excellent. Accurately adjusted all four wheel's toe in and the car now drives, rolls efficiently. On my 40 yr old GMC pickup rear wheel drive this tool did not accurately measure toe in due to the fact that with this type of steering mechanism the toe in varies according to how much weight is suspended by the wheels. Even if you place the jackstand near the outside of the control arm it's still out somewhat which leaves you guessing. The tape measures are very low quality, otherwise I would rate the overall quality higher. Better than no tape measures and it's good to have a matched set. The stainless steel alignment bars are good, fit on a variety of different wheel hubs. I would recommend a level for setup. Never work under a vehicle with even the slightest chance of it falling on you.

Produkten fungerar som beskrivs. Pris prestanda är bra för denna produkten som skall ses som.ett hjälp verktyg vid utbyte av komponenterna framtagning.

Used to do accurate alignment on my Willys jeep. Simple to use on old vehicles. All you need after replacing tie rod ends.

Als Einstellwerkzeug geeignet, die Standfestigkeit müsste verbessert werden, da die Platten zu leicht verrutschen.