Reseñas de clientes para VEVOR Gato Neumático de 3 Toneladas, 3-8S con Columna Elevada y 6 Tubos de Acero, Compacto, Fácil de Levantar con Almohadilla de Goma Gruesa, Apto para Sedán, SUV, Camioneta, 510 x 255 x 115-274 mm

Déjà assemblé et tester sur ma corvette C5 à amortisseur pneumatique

Un excelente producto, muy cómodo y fácil de utilizar, yo los trabajo en carros pequeños, sedanes, hatchbacks, coupes, Me ha resuelto muchos problemas en el que hacer diario de mi taller en: Funcionalidad Comodidad Ligereza Almacenaje Y algo muy importante, seguridad

So much easier than dragging a floor jack and much easier to center on lifting points. One note the air line between the valve and bellows was to long by at least 3/4". I had to cut the excess as it would've kinked. The nut on the air line did not slip and started to twist the vinyl hose, I had to apply dish soap and was able to secure the line. It works great I purchased the lowest profile 4.5" collapsed hieght slips under Audi S3 and the extension piece closed the gap on LR Discovery Sport. This makes the tire swaps easy, I would recommend.

parfait

Bon rapport qualite prix

But to be honest I wanted the 3 bag one and I guess when I clicked on it I assumed it was the 3 bag and when I got it was the two after I used it once then I’m like geez so can’t return now back to putting a block of wood. So make sure your double check when you click on the part so don’t get the wrong one like I did. It’s very good tho but not for my use still 5 star.

I can only recomend this jack. It works great, easy to use, and does not take much room to store. I need to cut the "extender"down a bit so i can use it instead of the wood piece.

El usuario pensó que el producto era muy bueno y le dio una reseña de 5 estrellas.

I love it ! I'm thinking about buying a second one. If I were going to change anything, I would make the handles the same height of the collapsed height.

I really like this Air Jack it did have shipping damage to the box only. All the parts made it with no damage. One had a small air leak at the input valve to manifold. I repaired the sloppy 2 pc handle at the slide end and in the middle. In the middle just use a 1 (+.04 -.01) inch x 3 inch flat bar. and drill the holes 20mm apart 4 of them. Then a vice to tighten up the side plates .it really makes it solid . The bottom I got some brass washers made 2 for the bolt and 2 for the pins around 0.065 thick. Plus the 2 other parts in picture. Best to make the parts brass or stainless as rust could be problem as the unit must be washed down. Asking for ""double boxing" made no difference, single thin walled box for heavy item. Amazing it even go around the World in and be usable! Shippers must had been careful this time.