Reseñas de clientes para VEVOR Cilindro Hidráulico Largo para Grúa de Taller 8 T Soporte de Motor de Cilindro Hidráulico con Bomba de Pistón Único Base de Horquilla para Motor de Elevación, Mantenimiento Automático

smaller than expected but it does the job

ce vérin a des soucis il ne tient pas la charge ,même a vide il ne se stabilise pas au bout de 2 h il descend tout seul il perd la pression je demande un remboursement .Cordialement.

Air actuator does not work at all

Leaks down in seconds probably because the valve was wide open and painted so it will not seal properly, still trying to figure out how to return it

Montado el hidraulico en la grua, pruebo y va bien, a los pocos dias quiero isar la grua y el hidraulico no se aguanta se baja enseguida, he mandado varios mensajes pero no tengo ningúna respuesta.

Absolutely a mistake it didn't not work under air pressure from day one. As for the "So" called Customer Service it too was rediclious I sent numorous explanations in detail with Videos for proof and once l would get a response l was called a liar. Since l was told ithe eam was extended fully up. Absolutely NOT and lt took over the course of several days to get it across that it was not working So finally l received a email saying they were going to be sending me a total refund for the purchase. Meanwhile because I'm a Mechanic and had a motor to pull out of a customer's car l purchased another Jack and it works perfectly!!!

Leaked down right out of the box. Wouldn't hold the weight of just the lifting arm. Vevor gave me a refund.

The air pump struggles to lift even without a load. Definitely defective. plan on returning.

Used the unit two times it worked flawlessly the first time but would not even pick up 50lbs the second time not too impressed with this purchase

This Jack never worked for me, straight out of the box, I followed the directions to the point. Never did get it to work. JUNK!!