Reseñas de clientes para VEVOR Gato de Transmisión Hidráulico 1660 lbs Telescópico Vertical de Elevación 85 x 65 x 85 cm Rojo Acero Bomba Hidráulica de Pie de Elevación Gatos de Accionamiento Hidráulico de un Cilindro

The company was very difficult to deal with when trying to contact someone to do troubleshooting of the product I purchased

I purchased this transmission jack for.my shop it works fine but is defective it goes up no problem but it don't want to come back down I can't just ship it back to company so I'm stuck with it and the pad to pump up is very slippery

Overall this thing works as intended. The build quality or the ram and legs is good however everything else is lacking. The foot peddle has a bunch of play while jacking it up The platform rocks on top of the jack and I will be welding mine in place. The castors barely roll with anything on it, and the securing chain/anchor is junk. Just use a ratchet strap Instead. In all this will work as intended but you do suffer a bit for buying one so cheap.

Low quality. Does work. Missing parts and hardware. Slow.

They've changed fasteners that don't match the instructions, and the side leg brackets are now held on by lare socket cap screws. Look like you need an M12 hex drive not 100% sure of that as I haven't dug out my set. The casters are metal and will marr and scratch floors. I bought some M12 stem heavy duty poly castors to replace them with. Also would be nice if it had a rubber pad on the jack surface.

Upper cradle of the Jack is poorly made

The top needs to be made a 1/4 turn different. And the table needs to angle 2 ways not 1 .

I can’t complain much for the price, but it slowly bleeds pressure off and drops the transmission down slowly, which isn’t good when you’re trying to get a transmission in or out. I’ve had it less than a year.

This looks ideal initially, and with a great price. In reality, its underbuilt, the table it is very floppy, too small, and it doesn't even come close to lifting high enough. Thats the biggest issue. If youre going to use this on a regular car lift, you need a transmission jack that goes up a MINIMUM of 12" higher than these do. If you're only going to use a couple of times, its probably worth it. If you want to use it in an actual shop, get a real jack that goes high enough.

First and foremost the hardware is cheap and cheesy. Secondly the casters are absolutely trash-order good 1k casters when you order the jack, you’ll thank me later. Table is ok’ish side to side is useless and the tilt is super sloppy,and yes they used the same cheesy hardware for the tilt and side to side adjustments. The jack itself works but the ergonomics are more suited for people in the five foot tall range. But it does work-I would hate to use it daily to R&R tranny’s especially if I’m working flat rate commission lol