Reseñas de clientes para VEVOR Gato de Transmisión Hidráulico Carga de 0,5 t Elevación Carretilla de 2 Etapas Bomba Hidráulica de Pie de Elevación 85 x 65 x 85 cm Rojo Gato Hidráulico Profesional Gatos Estabilizadores Acero

Assembly was easy even though directions are a little sloppy. The foot pedal operation need improvements. the swivel bed is so-so when I had a 4l60 on the plate. My biggest tiff is the open / close vavle location is in a peculiar location and theyre needs to be improvements o the open/close vavle for precise adjustments

Received this jack with one of the orifices leaking, set screw is tight. I assembled anyway thinking maybe it was just residual from manufacturing and shipping. Overnight it left a huge pool of oil on the floor. I contacted customer support and was told I would get a response within 48 hours.....it's been a week and have not been contacted, even after sending 2nd email. Do yourself a favor and don't buy tools directly from Vevor.....there is NO Service after the sale. They got your money, now you're on your own.

They've changed fasteners that don't match the instructions, and the side leg brackets are now held on by lare socket cap screws. Look like you need an M12 hex drive not 100% sure of that as I haven't dug out my set. The casters are metal and will marr and scratch floors. I bought some M12 stem heavy duty poly castors to replace them with. Also would be nice if it had a rubber pad on the jack surface.

Wheel are terrible they don't sweval all the way around the locks are to big and the top i stead of straight up and down there angled but can deal with just really need to change the wheels out make it hard moving around

The top needs to be made a 1/4 turn different. And the table needs to angle 2 ways not 1 .

I can’t complain much for the price, but it slowly bleeds pressure off and drops the transmission down slowly, which isn’t good when you’re trying to get a transmission in or out. I’ve had it less than a year.

This looks ideal initially, and with a great price. In reality, its underbuilt, the table it is very floppy, too small, and it doesn't even come close to lifting high enough. Thats the biggest issue. If youre going to use this on a regular car lift, you need a transmission jack that goes up a MINIMUM of 12" higher than these do. If you're only going to use a couple of times, its probably worth it. If you want to use it in an actual shop, get a real jack that goes high enough.

It is hard to get it to go back down like it keeps getting stuck up and won't go own unless you force it to. Should be 100 bucks less for the quality

Unfortunately I've used this thing two times and the cylinder acts up, it is not tall enough I had to make an extension and I'm not a fan that there is no side to side tilt it's only front to back

I read the comments and did some research. Overall the price is great but Jack does not go high enough and I’m not a tall guy. Going to have to build an extension. The plate works well with an automatic transmission but I will have to fabricate something for standard Transmissions. As the cradle legs are lightweight. Would recommend as far as price as it works well overall.