Reseñas de clientes para VEVOR Extractor de Rótulas 25 Piezas Extractor de Rótulas de Acero con Adaptadores de Varios Tamaños Kit de Extracción e Instalación de Rótulas U-Joint Pasador de Anclaje de Freno Vehículos 2WD 4WD

Had to do a full front linkage replacement on a 2013 Ford F-150 XLT. Bought this to both press out and press in the lower Ball Joints. First one pressed out with a little heat, second one needed the to be started with a sledge, to overcome the rust ring, but as soon as it was flush, the next tap popped it out. Both new ball joints went in fairly easy. The only issue I had with this kit is the press adapter rings (there are 3) were almost too coarse in diameter to press my joints in, the medium one was too small, the larger one was half on the edge of the ball joint housing. After getting it to straddle that edge evenly, the press went well. It IS quite a comprehensive kit and I'll probably only use it one or twice, bought it because I wanted to make sure I had ALL the adapters I needed and I only needed 4 parts. It would also be nice if all of the plates and tubes had some identifying mark to match a part list, so you know what cars they go to. They do have a application list in the manual but it only applies to 2004 and below cars and trucks.

Work pretty good decent for the price

Sembra abbastanza forte, speriamo che non si pieghi durante l'uso

TODO MUY BIEN SE VE FUERTE GRADE

Works great. Very strong. Lots of adapters for different jobs. Would buy again.

Well guolity

Ziet er goed uit nog niet gebruikt. Maar dat zal ongetwijfeld wel gaan werken, het is grof spul waar weinig aan fout kan gaan.

High quality work great. Highly recommend. Only flaw was tools not marked. Other than that solid performed as desired. Not to mention an awesome price point.

I purchased this tool to replace my ball joints on my 2005 F-250. It did a great job removing my uppers and lowers. It was not able to install the lowers and i had to use a hydraulic press. It installed the upper joints flawlessly. It is also handy to press the brake calipers in for reassembly. I think it will work great on cars and light trucks.

Bought this to check it out.. We were rather impressed with the quality. I had to remove 1* due to the utterly incomprehensible instructions.. Has only 1 pair of ball joints done with it so not sure as to how long it will last but so far so good.