Reseñas de clientes para VEVOR Extractor de Miel Manual de Acero Inoxidable 340 mm Centrífuga Separador de Miel 2 Marcos con Tapa Transparente Soporte Altura Ajustable 30-38 cm Equipo de Extracción de Panal para Apicultura

Built sturdy and easy to use. The lids are not perfect but they work. I thought I might get tired of turning the handle but momentum keeps the unit spinning and is not hard to turn at all.

ottimo prodotto, qualità ottima, già usato in produzione del miele comodo da usare e da poter pulire, facile nell'assemblaggio.

Well made honey extractor. The legs makes it easier to drain honey from extractor. I had an extractor from another company and this one is much better in so many ways.

I like this extractor (3 frames, manual drive). Yes, it jumps around during use, but for the price it's a great little machine. It will have a place in our small apiary (2 hives) for a long time.

Everything is looking good,,I won’t be able to use till next year,but it is very solid,and should do a great job !!!

It is built well. You will want to anchor it to a plywood base to keep it from wobbling around. Three frame holders worked well for our small operation.

First chance to use. I found this ideal for a budget minded home beekeeper like myself. The operation is all but frictionless, even the crank handle has bearings in it. Very easy to spin three of the largest Langstroth frames. The lids fit snugly enough to seal the chamber and seal out bugs if you got to lunch yet can be totally removed and put aside allowing painless access to insert or extract the frames. The bottom spout is quite sufficient to hold the contents and operates smoothly. The frame cage sits on a single ball bearing already greased, just be careful when you clean not to let gravity or force of water blow it out and lose it. However, it looks like it could be cleaned not even removing the cage with no chance of losing the special grease and ball at all. I didn't but it very likely operates even better and faster if the three legs are bolted down (holes already drilled in legs) to a floor or 4'x4' piece of plywood. Assembly was short and simple, easy enough to take down and store. Light enough to be lifted and stored in my attic space. I am very satisfied with this purchase.

Ich bin sehr zufrieden mit der Honigschleuder. Leider fehlten die Schrauben, um die Füße zu montieren (kann mal passieren...). Ich habe dann ohne Füße geschleudert, ging auch :) Die Schrauben wurden mir nach Prüfung schnell nachgesandt und ich wurde regelmäßig über den Status informiert. Trotz fehlender Füße, alle Sterne :)

The honey extractor works great for my needs. You do have to be careful putting the thicker end of the frame into the recess of the holder. Otherwise it will hit the top when you are spinning. But it's very effective with only 15-20 seconds per side

We are new bee keepers and couldn't wait to borrow our local bee associations extractor. This price was right to invest in our own. It arrived very quickly and was easy to put together. I mounted mine to a 4x4 piece of plywood with rubber washers and feet to help with vibration. It worked great! We left the lid off as it made a lot of noise because it's not attached. No "clutch" on the handle but what do you want for such a great price? Clean up was easy with a cold then hot hosing out. I would recommend!