Reseñas de clientes para VEVOR Extractor de Miel Manual 2/4 Marcos Centrífuga Separador de Miel de Acero Inoxidable con Tapa Adecuado de Panal Tamaño Profundo 48x23 cm Tamaño Mediano 48x16 cm Altura Regulable para Apicultura

It was a good machine for a small honey harvester. I used it two seasons, harvested around 400lbs of honey and the leg weld broke. Ihad it bolted to the floor and did my best to be careful amd easy with it. The legs are not attached well at all. AND when I originally looked at the product the advert was misleading because the legs LOOK like the bolt on. It was decent for $125. I wouldn't buy it again though.

Bonjour, je vous ai acheté un extracteur récemment, et après 3 hausses, il y a un gros bruit qui me semble pas normal. j'ai trouvé au fond de la cuve, dans le support axial, comme un liquide métallique (pas très bon si ça se mélange au miel). J'ai enregistré une vidéo, je voudrais vous la transmettre, avez-vous une adresse mail ? ça m'inquiète un peu vu que le produit est neuf. qu'en pensez-vous ? merci

Pentru cei cu rame mici este excelent.

For a first extractor, this one is not bad at all and very easy to use. You do have to work with it quite a bit to get it stable and wind up the frames slowly to keep everything in balance, but for a first piece of equipment it did just fine.

It functions well so far but the lid does not attach and when spinning, the frames sometimes hit the lid as it's moving around unless I held it with my free hand and that was hard to do! I'm not sure if there's something missing or not. Seems like the lid should be attached on hinges. Also, there's no brake

Matériel livré très rapidement, coût intéressant. Matériel fabriqué en Chine, pas très stable lorsqu'on tourne la manivelle un peu rapidement. Une des pattes s'est cassée à la première utilisation.

The thread on the valve doesn't work

Out of control when spinning with frames. Not very stable when spinning. Price is good compared to other brands.

The honey extractor has the lowest quality of legs. The legs are so flimsy that the extractor acts like an off balance washer. I laid my body across it but it didn’t help. I am going to have to have new legs made that are sturdy. Only other complaint was one of the screws that holds the crank in place was bent. Other than those two things I wish Vevor had pointed out that the four sides were not the same side.

The purchase was not accepted and was sent back to you. Please check it and refund my payment.Thank you!