Reseñas de clientes para VEVOR Extractor de Miel Manual 2/4 Marcos Centrífuga Separador de Miel de Acero Inoxidable con Tapa Adecuado de Panal Tamaño Profundo 48x23 cm Tamaño Mediano 48x16 cm Altura Regulable para Apicultura

This unit will work for 2 deep frames or 4 medium frames. For a small scale operation it works okay. Assembly was easy. Pros are the price. Cons are that if you are using a screen sieve on top of a 5 gallon pail to collect the honey you will need to set it on 2x4s or the gate won’t be high enough to clear it. Not a deal breaker. Instructions suggest bolting the legs to plywood but I used it without doing it. You do not have to spin the frames fast in order to spin out the honey. A couple of minutes per side is all you need.

Our extractor arrived quickly, and works wonderful, but when it arrived one half of the lid was broken into pieces. I took a picture and emailed it in, but never heard a real back. It would be nice to have the lid completely in tact, if pos

Bad customer service no free return

It was a good machine for a small honey harvester. I used it two seasons, harvested around 400lbs of honey and the leg weld broke. Ihad it bolted to the floor and did my best to be careful amd easy with it. The legs are not attached well at all. AND when I originally looked at the product the advert was misleading because the legs LOOK like the bolt on. It was decent for $125. I wouldn't buy it again though.

Pentru cei cu rame mici este excelent.

For a first extractor, this one is not bad at all and very easy to use. You do have to work with it quite a bit to get it stable and wind up the frames slowly to keep everything in balance, but for a first piece of equipment it did just fine.

It functions well so far but the lid does not attach and when spinning, the frames sometimes hit the lid as it's moving around unless I held it with my free hand and that was hard to do! I'm not sure if there's something missing or not. Seems like the lid should be attached on hinges. Also, there's no brake

The honey extractor has the lowest quality of legs. The legs are so flimsy that the extractor acts like an off balance washer. I laid my body across it but it didn’t help. I am going to have to have new legs made that are sturdy. Only other complaint was one of the screws that holds the crank in place was bent. Other than those two things I wish Vevor had pointed out that the four sides were not the same side.

The purchase was not accepted and was sent back to you. Please check it and refund my payment.Thank you!

Machine is OK but the plastic ring to seal the hole for the spout is of very poor quality. Cannot fix is and seal it properly it keeps on popping. Was clearly made too short. else than that the machine works fine.