Reseñas de clientes para VEVOR Aspirador de Vapor de Soldadura Ventilador de Trabajo de 150 W Filtro de 3 Capas 332 m³/h Absorbente de Humo para Soldadura Compacto para Reparación de Teléfonos de Soldadura DIY Impresión 3D

Works well for flux core wire welding. I'm using it in a single bay garage. Before buying this, a couple tack welds was enough to smoke the place up bad. Using this I am able to weld continuously with no noticeable smoke in the air. It does need to be positioned fairly close or above your weld, but it does work well.

As a fume extractor on a workbench, it’s perfect. Easy to set up, runs quiet, doesn’t take much room, stays in place.

I’m using it as a solder fume extractor on my workbench. It is well-made, very professional looking, it service my needs very well. The unit itself is very quiet. I just wish it was a little bit quieter on the hose intake side.

I am very pleased with how well this takes fumes out of my work area! It was shipped promptly, assembled easily and was simple to understand.

I purchased this to use with my XTool S1 laser cutter. The device is relatively quiet and removes all the smoke coming from the XTool exhaust. I will also plan to use it to filter solder smoke.

No issues here. Fast shipping. I was heavier than I thought, no problem though. It is in use with my fiver laser engraver and it just works.

Use this when laser engraving inside . Works quite well for what I do. I have a enclosure that I have this attached at the exhaust port of the enclosure and catches most of the smell and dust.

it works as advertised, I wish that the air intake was wider so it could be farther away from my work surface.

.

I purchased the fume extractor for my laser engraver and it does a very good job at cleaning the fumes from the air. I don't have any way to check the air quality but I don't smell anything when using the machine. So, I believe it is doing a good job. I would buy again and I do recommend.