Reseñas de clientes para VEVOR Extractor de engranajes con rodamiento interno, extractor universal de 2 brazos de 75-138 mm, extractor de cilindros de acero 45, 7 placas de extracción, extractor manual de carcasa

Worked great on removing sleeves out of 2 different engines. No complaints yet.

Fungerar väldigt bra! Gedigen och väldigt kraftfull. Avdragaren är kraftigt tillverkad och är riktigt robust. Drog ur cylinderfoder på min traktor (Bm 700) och det gick smidigt fast fodren satt väldigt hårt. Satsen hade tom ett bottenstycke som passade exakt. 105.5 mm. Medföljer olika bottenstycken och alla är vändbara med två olika mått till omkrets på foder. Svängarmen är lagrad med ett löst lager som sätts på gängstången. Lagret gör att man lättare kan snurra svängarrnen och man nyper inte fast gods mot gods. Mycket prisvärd och välgjord!

Great product. Was able to pull the sleeve out of an old tractor I was restoring.

produit conforme mieux que je pansais fonctionnel facile a utiliser une foie pris en main seul bémol les tubes de pousser a positionner manque un système de positionnement sinon super.

Purchase this to pull liners on an old Yanmar 1700 tractor. Work great. Built well. Can’t beat the price.

Nice product, quick shipping,but only downside for me is it won't work for my engine was supposed to according to other people but the plate is to large for the bore and next one down is to small,but that was not vevor s problem other than that seems to be well made I would just make the stand offs into the cross bar because it's a little wobbly until you get pressure on the tool

Used this kit to remove the liners on a continental z120 engine out of a ferguson te-20. Worked really good, made sure to put axle grease on the thread of the puller rod and on the pancake bearing. Really impressive for the price since these liners were pretty caked up in there.

Not fancy but works great. May need to deburr a couple spots but totally worth the price. I'd buy it again without a second thought!

It worked pretty well. Just make sure you put grease on the threads before you start pulling and put some washers underneath the propping tubes because their sharp edges could damage a block.

This tool worked perfectly for pulling the cylinder sleeves on my Massey Ferguson 135. It made my job so easy and the price was amazing.