Reseñas de clientes para VEVOR Estante de Almacenamiento de Filamentos 7 Niveles para Impresión 3D Soporte de Metal para Carretes de Filamento 840 x 320 x 1650 mm Estante Fijo para Estudios, Talleres, Oficinas, Negro

Could be a little more sturdy but holding up well loaded with spools. Definitely wobbles while printing but not enough to offset prints.

I use this cart for my Bambu A1 printer which fits nicely on top. I wish that there was another solid wood shelf. The two lower racks for reel storage are a bit excessive and there are lots of accessories I rather store on the cart. Four locking wheels (comes with two) would be an improvement as the Bambu does a vibration test for each print and the cart shakes a bit. The cart takes a while to put together if you only have hand tools. I used a hex bit and my drill and got it together in about 30 minutes.

I was looking for a filament storage rack and came across this. I took a chance and purchased it because it holds 60 spools for filament in the rack below the printer shelf. Because it's on wheels it makes it easy to move around. The rack is pretty sturdy (enough for printer spools and a MAX - size printer). While my Neptune 4 MAX printer hangs over the end I was able to get a piece of 1/2" plywood to place on the top to accommodate the depth of the MAX printer. It will EASILY hold a standard size 3D printer. I'm very happy with the construction. The only reason I gave it 4 stars instead of 5 is because the wood top part was not drilled properly for the attachment screws. The back screws are fine but the front screw holes are too far away from the frame bar, so I had to drill new holes and use different screws to attach the top to the frame. Otherwise, I highly recommend this rack/table.

Nice rack for the price, could use a few minor improvements to make it much better. It is a little wobbly due to the nature of how it's put together. This is where one improvement could be made, . A radius is needed where the rack connects to the rails. If it were radiused connections rather straight it would made a much more secure connection and eliminate most of the wobble.

product is of quality to excpect for the price. except the feet of the stand where the holes didnt match, so i had to modify it my self to make it work proberly. once you fix the issue product is okay and does what it needs to do. two stars due to unfinished product

good for like a closet underwhelming for a large room. a normal desk with ams is the only way to go if you are printing

Dålig ena popnuten va lös så går inte montera ihop

No va bene, troppo piccolo

Hi, I haven’t received my package. It has been sent back to you due to an issue with PostNord. How should we proceed? Best regards, Brian Hansen

use caution item is not what is pictured. although i sent them pictures and they refunded me. Vevor still has not updated the picture. There is no top spool rod and its very flimsy shakes like crazy...also has two bars to install which would make it more stable but cant install them because the Bambu P2S wont fit if the bars are both installed so I installed only one which pushes against the power cord but yeahhhh...you pay for what you get...but again do not go by the picture...its incorrect...