Reseñas de clientes para VEVOR Dobladora de Tubos Manual Dobladora de Tubos con Carraca 10-25 mm 7 Matrices para Doblar Tubos de Cobre y Aluminio a 180° para HVAC Aire Acondicionado Frigorífico Automóviles

Je l'utilise occasionnellement et je le trouve top. Les courbures sont très propres et le matériel est robuste. (essayé sur du tube jusqu'à 18mm...) Donc rapport qualité prix c'est un très bon choix. D'un point de vue pratique, il y a mieux car certaine marque propose des repères qu'il n'y a pas sur celui-ci mais le prix n'est plus du tout le même...

Faz exatamente ao que se propõe e melhor ainda. Ferro,inox , alumínio, latão, multicamada. Tudo sem stress, desde que não ultrapassem as medidas da matriz e espessura recomendada.

Kipróbáltam, működik, de még nem használtam. Remélem, hogy beváltja a hozzáfűzött reményeimet. Egyelőre mást nem tudok nyilatkozni róla mert konkrét munka közben még nem használtam.

1 ) Ótima qualidade/preço. 2) Máquina manual robusta. Utilizei para curvar tubos de inox com 25mm de diâmetro e espessura de 1,25mm e funcionou muito bem. No entanto, é preciso algum cuidado com a guia inicial (furo de fixação do tubo) para não deixar marcas/vincos. Se esta peça tivesse maior espessura e com as esquinas mais ovalizadas, talvez o acabamento final seria mais perfeito. Conclusão: muito satisfeito.

So far I haven't used it. Want to bend up some 3/4 thin wall tubing t build a mini bike frame. Trying to figuire out how to mount it to something thet won't move, such as a lolly column in my garage. One thing I did modify was the adjustment knob/roller, by knurling it so it's easier to turn. Helps much.

Item works great, does every thing I needed, have used it quite a few time already, needs a solid base to bolt it too then creates fantastic curves

It works, even with 25x1,5 mm stainless tube. ........................................................................................................

Reçu rapidement comme d'habitude, très costaud, pas essayée mais pas de raison que ça fasse pas le taf...

C'est pas du matériel professionnel, mais ça fait le travail pour un amateur. Ça plie du20/27 tranquillement Je valide largement

The first task on receiving this is to get it mounted. I had a bench grinder pedestal made with a bigger/thicker upright and bolted it to concrete with 8mm thread dynabolts. Then had to drill the top plate to fit - its not mounted squarely, but that's ok. Bent my first tube. All good. I am working my way up to 1” tube (at 7/8” now). You get a mark on the tube at the tube retainer. I have tried to put shim steel in to buffer the tube, it still marked, but not as deep. I have some 3mm leather to try, but will have to swap the retainer off the next size up die, and with 1” tube I wont have a next size. The only features I would like would be a carry case (i have seen other vendors with a case, but it doubles the price) and an angle pointer for repeatability when bending more tubes the same. My best suggestion is get extra tubing and practice before making your final parts.