Reseñas de clientes para VEVOR Dobladora de Tubos de 6-22 mm Kit de Dobladora de Tubos con Trinquete para Refrigeración 7 Tamaños de Troquel Dobladora de Tubos Frontal y Trasera de 90° Accesorio de Doblado Inverso para HVAC

First, for the money, I really have no complaints. It does actually make very nice bends in tubing up to size 7/8" However there are a couple of annoyances that could be addressed to make this a world-class tool instead of a "really good" tool. * The pressing block (the curved part) tends to fall off. There's a little spring (maybe?) but it's not up to the task. * The handles are too short, and don't give enough leverage. Either the gearing needs to be changed to require more handle pumps, or the handles need to be longer. It took two hands and everything I had to bend some 7/8" refrigeration tubing. * The molded case needs to have a large diagram stuck on the lid showing where everything goes. It's not very intuitive and while there is an ad with a postage-stamp size picture enclosed, it's very hard to see. The short story is "If you need to bend tubing, this works really well, although not as good as it could"

Ottimo prodotto

Honnêtement je n'étais pas convaincu de la performance de l'outil qui était annoncée. Mais après essai je confirme qu'il fonctionne bien ! Cela mérite certainement un peu d'entraînement pour realiser des pliages precis aux endroits voulus, mais lors de mes essais l'arbalète à pliée sans trop de difficulté des tuyaux en cuivre de 14 et 22mm. Bien entendu il faut bien recuire le cuivre avant de le plier. L'arbalète semble solide, on verra avec le temps si elle tiens ses promesses. Seule petit point les dimensions sont en pouce, pour le tuyau de 14 il faut utiliser le profil 1/2, pour le 18 il faut voir si le 3/4 fonctionne, ou si il y a trop de jeu. Mais pour le prix je suis très satisfait de mon achat

Se ve todo de muy buena calidad incluso mejor que una curvadora que ya tengo de Rems

Perfecta

all around good tool, I needed for installing line set, read reviews and researched, some said it kinked lines so I experimented with various techniques and its all about he copper line, heated the 7/8" copper up to anneal it and then bent it and no kinks!