Reseñas de clientes para VEVOR Dobladora de Cajas y Bandejas Portátil 850 x 390 x 365 mm Ángulo de Curvatura de 0-135° para Acero de Bajo Carbono Calibre 20 y Aluminio Calibre 14, 5 Dedos Ajustables para Doblar Metal

This unit bends material but does not bend 20 gauge steel with out flexing if you bend material wider than 15 inches. Thinner material it works also when the bar flexes the pivot pins come out even after installing set screws that were missing apon arrival. As stated it works on thinner sheet metal but not 20 gauge as stated. I am not returning this unit as I will use it for lighter material but will look for something substantially heavier. The price was good the description needs to be updated is all

Do not waste your money. I guess the old adage of you get what you pay for is true. One of the screws that is used to hold part of the brake down to secure whatever material you are bending was badly bent and could not be tightened. Reaching out to customer service provided no resolution, even though follow up emails stated the issue would be resolved in 24-48 hours. It has been over 72 hours and nothing has been done. If I could give zero stars I would. Customer support does not care, they just want your money. Stay away.

I bought this to bend 14g aluminum sheet and the handles bent first try. I didnt give zero stars becuase other than the handles it seems to built well. Not recomended for the higher end of its limits.

Looks quite capable enough for DIY work Unfortunately the unit was damaged before packing - Bent right side mounting plate, not that it prevents the unit from operating . A bit anti corrosive treatment at the factory would be a good idea as rust was visible and needed treatment when removed from packaging. Unable to load images due website restrictions.

It looks beefy but it has too much flex in the center. The ends to center are off by several degrees. I would recommend using with larger gauge than recommended.

That old saying ,you get what you pay for. The wing nuts that hold the mid plate down we’re to large so the brake would not close,and in my opinion the bolts used could have been a better quality and a touch longer. I also had to grind out the mid plate holes as it was binding on the bolts.So all in all I spent an hour of my time and two new bolts so it was usable.Now it works awesome have bent about 50 pieces of sheet metal so far.

This bender seems to be of reasonable quality and is reasonably priced. I wasn't able to actually use it as it is not adjustable to enablebending of anythinggreater than maybe half of a millimetre. It is probably ideal for the hobbyist to bend very light gauge sheet metals.

Bought new and can’t even use it. The machine is not in alignment so anything you bend is 1/8 off on one side waste of money.

Absolutely useless. Wouldn't bend 1mml. Brought this as it advertised it could do what i wanted it to do. i literally just needed a couple of small folds in some 1mm, and it couldn't do it.

Well the item never arrived and vevor couldn't even tell me where it was or what happened to my order. Worst experience of my life. Then I never received a refund. There are no actual people to talk to for customer service. I wish I could give 0 stars. Vevor sucks. Will be turning into better buisness bureau for sure.