Reseñas de clientes para VEVOR Dobladora de Cajas y Bandejas, Dobladora de Chapa Metálica de 122 cm, Capacidad para Acero Dulce de 2,5 mm, Ajustable de 0-135°, Máquina Plegadora de Metal con 8 Dedos para Doblado Preciso

12 Ga Would be a bit of a stretch for this break. at least at the full 48" width. I'm confident it could do small brackets at 12 Ga. my first project was a 18" 14 ga Bracket at it was flexing the Fingers at that thickness. I wouldn't do more that 16 Ga at full 48" if i wanted a long life out of this tool. but overall it seems well built and I'm sure it will work great for years if i don't over use the break

Tanto para aficionados como para pequeñas empresas, esta dobladora de chapa entrega resultados profesionales. Una herramienta imprescindible para trabajos en metal.

So... This brake is heavy duty, for sure, and I am confident it will consistently bend the 12 gauge steel I use to sculpt--- The welds are sub par, but the body is made of mostly 1/2 inch and 3/4 inch plate steel, and the adjustments are everywhere and effective, --- But OMGoodness it is awkward to move around. Even with a forklift, when I tried to lift and move it, I accidentally dropped it, as part of it shifted. Eventually, I figured I had to chain the entire top mechanism in place to effectively lift it, and it's still so top heavy (the feet and legs are thinner metal, enough to hold it up, but not enough top counter weigh the top) that it tilted forward and fell off the forks, again! Call me stupid, because o guess brakes are often like that, and moving them has often been an issue for folks in the past--- Just- be so careful! assemble it in place, and if you try to lift the top off of the bolts the keep it fastened to the shipping box, (so you can instal the legs and feet) chain around it several times before lifting, or it will fall apart and land on its face. Really--- I had a heck of a time assembling and moving this thing, with several heavy accidents. Luckily, it's thick and solid, and the working components didn't bend. The only bends I made were in the foot tabs. They bent as I was lifting and dragging the unit back upright after installing the legs- because it was on its face... because I didn't chain it up before lifting the top off the shipping bolts... blah blah blah... Nice unit, for a nice price. You need a forklift, or 4 olympic weight lifters to assemble it.

Used it in my small fabrication shop for bending aluminum, stainless steel and copper. The clamping system holds metal tightly, bends are clean and consistent. Worth every euro for reliable results.

This brake stripped its adjustable set pin after the first week using. Sent this to vevor and got no response. I only used it for 14ga sheet metal a few times.