Reseñas de clientes para VEVOR Cortadora de Plasma de 50 A y 220 V con Inversor IGBT y Pantalla Digital, Control Inteligente, Función 2T/4T y Tiempo PA/PT Ajustable para Reparaciones Domésticas y Talleres para Garajes

Received this unit today, set it up and tested it. Instructions beyond labeling of components are non existent. Troubleshooting is for a welder! After a couple of hours of screwing around, I found that 4 of the 5 tips I was shipped were defective and produced only a very weak spark. Luckily one tip worked so I could verify that the unit was operable. The electrodes also look very cheap, so I would recommend shopping for some higher quality consumables right away, and you'll have to Google the settings for air pressure, 2T vs 4T operation, current settings etc. The unit seems ok, but it's frustrating trying to troubleshoot multiple faulty components on a new unfamiliar item. Picture of my faulty parts below for reference.

Suite à quelques utilisations je suis arrivé au moment de remplacer les consommables et malheureusement lorsque je les remplace par les consommables fournis le poste ne fonctionne plus j'en ai donc commandé sur un autre site et idem je ne sais pas où avoir des consommables identiques à l'origine monter sur la torche.

It does fine with small cuts but if youre trying to make long cuts it tends to overheat and shut off. Ended up buying an Arc Captain Cut65MP and am so happy I did.

Having problems getting this thing to work properly. No number to call for support. Online bots were no help

so far 1/5. out of box failed - Pilot arc does not function, looks like high frequency cct is likely the issue. - 4T also does not work.. 4T functions the same as 2T.

jeg modtaget den i dag og åbent kassen og fandt jeg ud af at der er noget af nogen af delene er brugt 😡 Det er bare ikke i orden at jeg ikke længer kan stole på jer!!

premiere utilisation et la torche crache des flammes par la gachette ,je viens de poser reclammation on verra bien , pour le moment c'est 1 etoile et zero si je pouvais ,suis degouté

Ha funzionato bene per le prime ore, poi ha iniziato a interrompersi a metà taglio. Si è arrivati ​​al punto in cui era difficile mantenere stabile l'arco plasma... Ho comunque finito il lavoro, ma consiglio una marca più costosa, come Telwin, se si deve tagliare molto acciaio. Quando ho finito di tagliare la vecchia caldaia a gasolio, non riusciva più a eseguire tagli lunghi più di un centimetro prima di interrompersi, anche dopo aver sostituito gli ugelli della torcia.

It's no use

Yesterday, I lost my patience with this tool; I’ve been trying to get it to work ever since I bought it. I thought the issue might be the three-phase electrical panel, so I replaced it—still nothing. I thought it might be the torch, so I bought another one. I thought it might be the cold weather and high humidity, so I even bought 3-stage NPT filters—but it still doesn't work. I tried adjusting the pressure, but it won't strike an arc at all. Occasionally, when it makes contact with the metal plate (to which the ground clamp is attached), it produces a spark and starts up. I wouldn't recommend this tool to anyone; it’s a total failure—I haven't been able to use it for anything.