Reseñas de clientes para VEVOR Máquina para Fabricar Botones Diámetro de 58 mm Cortador de Círculo de Insignia 29x15,5x48,5 cm Hierro y ABS Máquina para Hacer Pines Chapas Lazos Llaveros Abrebotellas Personalizadas 500 Piezas

L'aimant qui connecte la pièce du milieu es détérioré donc impossible de créer des badges.

Buttons werden ausnahmslos alle unbrauchbar

Had extreme difficulty in assembling due to poor quality in mold. Base was rocky and bolts were too short to grab the threads. Once assembled I could not exert enough pressure to crimp the pin together. Used different thickness of paper and reduced sized of paper circles. I have used button presses over 20 years and this is the poorest quality and design and easy to tip over during the extreme pressing cycle

I have the 1" version which came with both plastic backings. The plastic backings are not useful, I haven't made a successful button with them yet. I get a successful button about 1/3 of the time using the metal backings. I cannot recommend this product.

La máquina no funciona de la manera correcta, tenemos tiempo trabajando con botones en nuestro emprendimiento y hemos tenido que cambiar de máquina por qué llegamos a europa pero está máquina no es buena, viene desajustada lo que hace que dale los botones es una máquinas para que los niños jueguen no recomendada para uso prolongado producción masiva a pesar que la envían con 500 juegos de botones, los troqueles no calzan bien NO LA RECOMENDAMOS PARA NADA

Dies would not fit together making it unusable. Looking at the press it is low quality with no quality control. Wanted a refund but they insisted sending replacement dies. Dies were out of stock and after a month wait the dies arrived with same issue. I'm just giving up at this point waisting no more time with these jokers. Complete waste of money!

I had high hopes for this product, but have been greatly disappointed. Once I was finally able to put it together I get maybe 1 button out of every 5 I try to make. Even those don’t look completely right. The plastic film and paper don’t get fully crimped around the parts. It’s also very hard to use. I struggle to pull the handle and get it to fully engage. Super frustrating!

The button maker worked good, for the first couple of times that we used it. We didnt touch it for another 8-9 months and then the next job we were doing the button maker started pushing out bad buttons. The tops in the same spot on every button were not sealing the plastic or the picture.

Traté y Traté con todo lo que me decía elmanual y nada, no pude hacerla funcionar con las tapas de plástico, y viene muy débil la presión, funcionó ligeramente con las tapas de metal pero era un 50/50 los que funcionaban.

Have not received product, have emailed company twice and no response at this point, very, very disappointed.