Reseñas de clientes para VEVOR Cortador de Azulejos 1200 mm Cortador Manual de Azulejos Muela de Corte de Carburo de Tungsteno Posicionamiento por Infrarrojos Pies Antideslizantes para Instaladores Profesionales Principiantes

El cortador muy bien pero lo compré porque ponía que llegaría al siguiente día y tardo casi 3 semanas

Der Fliesenschneider ist nicht eingestellt, der Modus ist nicht genau

Dommage que la règle perpendiculaire à la coupe ne soit pas d'équerre ainsi que le laser, ce qui oblige à tracer des 2 cotés du carreau et visé la molette de coupe

I purchased this tile cutter for as I am doing my bathroom tile. The laser wasnt the best to use. Also, the tile saw kept cracking/braking my tile once I got towards the end. You needed to apply a decent amount of pressure for it to break evenly. A few taps didn't work for my tile. I have 5ftx3ft tiles and I wouldn't recommend this cutter for these type of porcelain tiles. Maybe smaller tiles it would work for. I ended up using just a circular saw with a very good diamond blade which made cleaner cuts.

Quality is ok. But the middle flexes to much and doesn't score the tile. Other ones have support there. So I have to push down on the center section. Not fun. Wish I would have returned. Not a good long term solution.

Could not get the laser to calibrate. Not easy to line up. Once lined up it cuts nicely.

The cutter is not square so the laser does not help. To make exact cut, it is necessary to place a tail checking whether the cutting wheel is placed on the top of the intended cut line on the one side of the tail, then on the other side so preparing for the cut takes time and adjustment. Beside of that, the video of the product and the manual attached to the product depict totally different version of the cutter (the real one does not have side supports and adjusted angle ruler). Customer service was not helpful at all so I did not get any replacement, I had to use what I got.

Poor design. There is a 2 inch piece of rubber near the top of the cutter which allows you to snap the tile however every time I tried to cut a 48 inch tile the cutter would get stuck causing a jagged section on the cut.

Very good tile cutter but, the laser line it's useless under the sunlight, the alignment can't be relied upon. If it had a decent strong laser line which could be adjusted by user and a decent top ruler that is accurate, easy to see and long enough for large tile I believe it vould be a competitive tile worldwide. I did a decent job with it but by only ignoring the laser line and marking my tiles first using a tape measure. Despite all this if you are not a perfectionist then you will not find a cheaper cutter anywhere. Cheers

Not the best, have to make alot of adjustments to get straight cuts, laser is never aligned with cutter don't bother using laser.