Reseñas de clientes para VEVOR Cortador de Azulejos 1200 mm Cortador Manual de Azulejos Muela de Corte de Carburo de Tungsteno Posicionamiento por Infrarrojos Pies Antideslizantes para Instaladores Profesionales Principiantes

tutto perfetto il diamante per incidere ottima qualità.....unico penso difetto e il pianale che tende a flettere troppo leggero e fino di spessore e il taglio alcune volte un risulta perfetto e la mattonella si scheggia per il resto tutto ottimo

Aparentemente muy completa y el láser es de gran utilidad. Por contra resulta bastante endeble y no trasluce mucha calidad

J’ai fait un travail avec cette scie a carreaux et je ne suis pas satisfait , le rail supérieur ou le couteau glisse n’est pas assez rigide , par conséquent , les grands carreaux sont plus problématique.

W przypadku wiekszych formatow płytki gresowej prowadnica sie wygina podczas przycianania i albo trzeba samemu dociskac prowadnice alvo musi robic to 2 osoba da sie uciąc ale maszyna jest za malo sztywna jesli ktos nie potrzebyje takiego dużego formstu proponuje kuoic mniejsza bedzie sztywniejsza

This tile cutter is defective. No strength; the frame is weak and can't cut tile without messing up one or two. I've never experienced this with my other tile cutter.

Board is flimsy and handle is too low. I can not cut any porcelain tile strip less than 2 in.

First of all, I’d like to say it’s a very good price which obviously means you’re going to get a cheaper product. If you’re just looking to do a couple of jobs this will get you by. It’s first of all the fence isn’t square and the laser beam is quite far off. You have to Jerry rig it to get it straight otherwise it cuts OK

The alignement of the cutter on the base is offset You have to align it and drill and grind the plastic at the end of the frame The frame is to soft When you cut and try to press to split the tile, the frame bind and it become hard to split I have to had steel piece under all the lenght the strength the frame After all that it's a good cheap tool

Poor design. There is a 2 inch piece of rubber near the top of the cutter which allows you to snap the tile however every time I tried to cut a 48 inch tile the cutter would get stuck causing a jagged section on the cut.

La maquina es frágil con nada se dobla o rompe no parte las piezas bien desperdicias muchas y si intentas devolver no te hacen ni caso mal producto