Reseñas de clientes para VEVOR Máquina de Cortar Azulejos Profesional 1200mm Cortador de Azulejos Ancho de Corte 35-1200 mm Cortadora de Piso Laminado Espesor de Corte 6-15 mm Cortador Manual de Azulejos de Aluminio Corte

jónak tűnik, de az összeszerelés hagy kivánni valót maga után. Pl. a lézer elemtartójának a fedele az első leszedéskor eltört.

buon prodotto e buon rapporto qualità/prezzo ma consegnato in ritardo e senza che VEVOR sapesse dove era finito

Es grade de uso profesional

Para calidad, precio a funcionado a la perfección

Loved the 24" tile cutter and it worked beautifully with one exception. The tubular cover at the top of the centre line is a little too high and the tile does not sit comfortably when cutting. Would I buy it again - Yes.

Todo perfecto corta super bien y sin apretar nada ni el diamante ni la palanca por el precio qe tiene es perfecta

I purchased this to cut 48" long tile because tile saws won't handle something this large (unless maybe you spend a huge amount of money). This tool scores the tile and you snap it to break the tile. It worked well for one type of tile but was difficult to get another tile to snap that was a little thicker. The break is not as clean as a wet tile saw, but I was able to put the cut edge along the wall so it is covered by trim anyway. The laser is nice to get the tile lined up for the scoring. Mine was aligned pretty well along the entire length of the cutter, but some have commented that this could be off. There is a little adjustment for the rails. I wouldn't pick this tool up with the rails - it is tempting because it makes for a great handle, but you may bend the rails. Overall a good tool at a nice price.

Clean cuts every time. Instructions could be better for the attachment of angle accessories. Laser light difficult to line up with score wheel accurately but overall very happy.

It cuts so easy , a D.I.Y must have . handles 600mm porcilian tile easily, straight and clean.the only problem I have with it is the cutter is not aligned straight and dose cut straight unless you mark at each end of the tile and make sure it`s going to those marks. I tried to realign the rail and got it to within a couple of mm and it is a pitty that I cannot just put a tile in and just cut it instead of fiddling around linnig up marks because the Rail is not square to the cutter.

The laser light is not neat enough and incorrect guidance. So it make the cutting edge was not correct as required. The balance of the device is not good when putting the tile on to cut. You have to hold the tile firmly when cutting