Reseñas de clientes para VEVOR Máquina de Cortar Azulejos Profesional 1200mm Cortador de Azulejos Ancho de Corte 35-1200 mm Cortadora de Piso Laminado Espesor de Corte 6-15 mm Cortador Manual de Azulejos de Aluminio Corte

La máquina está mal ensamblada, corta torcido, no saca tiras finas...Un desastre

Dommage que la règle perpendiculaire à la coupe ne soit pas d'équerre ainsi que le laser, ce qui oblige à tracer des 2 cotés du carreau et visé la molette de coupe

As barras não têm firmeza

Pues tras siete meses de uso puedo decir k deja mucho que desear para el formato 120 porcelánico va bien pero para otros de cerámica de 40 por ejemplo deja mucho que desear no parte bien no corta cuando va a media guía por k la misma guía se cirba hacia arriba y no ejerce fuerza en fin vale para algo puntual para herramientas profesionales no es de buena calidad...

I purchased this tile cutter for as I am doing my bathroom tile. The laser wasnt the best to use. Also, the tile saw kept cracking/braking my tile once I got towards the end. You needed to apply a decent amount of pressure for it to break evenly. A few taps didn't work for my tile. I have 5ftx3ft tiles and I wouldn't recommend this cutter for these type of porcelain tiles. Maybe smaller tiles it would work for. I ended up using just a circular saw with a very good diamond blade which made cleaner cuts.

The alignement of the cutter on the base is offset You have to align it and drill and grind the plastic at the end of the frame The frame is to soft When you cut and try to press to split the tile, the frame bind and it become hard to split I have to had steel piece under all the lenght the strength the frame After all that it's a good cheap tool

Quality is ok. But the middle flexes to much and doesn't score the tile. Other ones have support there. So I have to push down on the center section. Not fun. Wish I would have returned. Not a good long term solution.

Could not get the laser to calibrate. Not easy to line up. Once lined up it cuts nicely.

The cutter is not square so the laser does not help. To make exact cut, it is necessary to place a tail checking whether the cutting wheel is placed on the top of the intended cut line on the one side of the tail, then on the other side so preparing for the cut takes time and adjustment. Beside of that, the video of the product and the manual attached to the product depict totally different version of the cutter (the real one does not have side supports and adjusted angle ruler). Customer service was not helpful at all so I did not get any replacement, I had to use what I got.

Very good tile cutter but, the laser line it's useless under the sunlight, the alignment can't be relied upon. If it had a decent strong laser line which could be adjusted by user and a decent top ruler that is accurate, easy to see and long enough for large tile I believe it vould be a competitive tile worldwide. I did a decent job with it but by only ignoring the laser line and marking my tiles first using a tape measure. Despite all this if you are not a perfectionist then you will not find a cheaper cutter anywhere. Cheers