Reseñas de clientes para VEVOR Cerradura de Puerta Mecánica sin Llave Teclado de 14 Teclas Cerradura de Código Manija de Puerta de Entrada Exterior de Aleación de Zinc Fácil Instalación para Puertas Espesor de 35-65 mm

Bought the Vevor mechanical keyless entry door lock, 14 mechanical on October 09 2026. The key pads does not work on both side, and I like to return it for a full refund.

En ole koskaan saanut sitä. Rahan voi palauttaa tililleni takaisinå

purchased 7 of these. 1 was missing parts and 1 does not work. Support has been dragging me along for months and still has not offered to replace the defective units. Recommend not purchasing this particular model until they have the bugs worked out.

I spent 1 hour adjusting the fitment then it won't lock. I used the second set to finally install it. My tenant claims it was too complicated and didn't always work. I removed it replace with original and put it back in the box through it in the corner make it up as a lesson and a loss

No me llegó completo los accesorios de instalación

Je sais pas si c'est moi mais quand je lai installer, si je serre trop les visse qui assemble la pogné elle vient dure a tourner et la clanche ne veut pas ressortir alors j'ai abandonné et remis ma vieille.

I still have it somewhere < it came with missing parts < I called and they give me a lot of excuses for return, bad customer service

Installation is not easy because of the flat bar for actuating the lock. The instructions are sorely lacking in this regard. One end of the bar has two "dimples" which must go into the combination side of the lock. There are 2 different lengths provide. I found that neither one worked for a 3.5" install and the longer one had to be cut. I cut it too short and did not have a working one because I inserted it the wrong way around. I ordered a replacement unit rather than try to get the part from tech support. Good thing I did too because the original one would not stay open fully, but "rebounded" about .5 inch not allowing the gate to close fully. However once I replaced the combo side3 of the lock with the new unit, it worked. I also rebuild my gate with 2x6s laid with the 1.5" side to mount the lock so that was room for the mechanism without having to add a block.

This entryway pushbutton lock system works pretty good after its installed, but the assembly was nerve wrecking! The two screws that secure the two halfs together on the door are all but impossible to start and screw in. It took me one hour of sweat and cuss words to finally get it together!!!! Not for the faint at heart

The directions aren't real explanatory on how to change the passcode I had to Google it online to figure out how to change the passcode The directions in the manual suck