Reseñas de clientes para VEVOR Caja Eléctrica de Acero al Carbono IP66 Gabinete Eléctrico 30x30x20 cm Caja Impermeable con Placa de Montaje Caja de Conexiones Eléctricas para Equipos Electrónicos Eléctricos al Aire Libre

Très satisfait !

Trés bon matériel

In deze kast buiten aan de muur van ons huis zit nu een stopcontact voor de EV laadkabel. De kast is absoluut waterdicht en diefstalproof. Aanbeveler.

Super stabiler Schrank, erfüllt SEINEN Zweck sehr gut.Verpackung auch sehr stabil, kam unversehrt an. Weiter so.

Historically, I have built these cabinets from components. It is so nice to have a robust outdoor fan-cooled cabinet.

Worked as advertised.

Preis Leistung super.

Pretty good alternative to expensive Hoffman or Hammond eqyuivalents.. Steel is a bit thinner than those brands, but fit and finish are just as good Good value for the price

Prima kast zwaar metaal

The box is well built and it's really a good design. I really like the cooling fan and the ventilation. However, there are a few flaws to this design. First of all, if this is an outdoor enclosure, it should be bug proof 100%. Yes, there is mesh for the side vents on the inside of the enclosure, but then there is a big gaping hole at the bottom of each vent for flies and other bugs to go live in there. Over time bugs going in there to live and make nests and all that we'll plug up the mesh screen. So there should be a mesh screen at the bottom of each vent where the big gaping hole is for air to flow through as well as one on the inside of the enclosure. And same with at the top where the fan vents out. There's little slotted holes for the air to go out of the enclosure from the fan. And there is a mesh screen between the fan and this little opening where the air blows into. But again flies and all kinds of other little bugs are going to go live inside of there. So where the little slotted holes are there needs to be a mesh screen covering that as well. So no bugs can go live anywhere in this enclosure. Also there are pre-drilled holes for mounting hardware. There's two at the top of the enclosure and two at the bottom. The metal insert that comes with the enclosure is too close to the bottom holes for the supplied nuts and bolts that come with this kit. The nuts that come with it are huge and the holes on the bottom are too close to the insert for these knots to even have space to spin and tighten on. Let alone get a socket bit on there. The top holes are okay. I was able to get the socket on there. But I had to use smaller nuts and bolts for the bottom holes. It would just make sense if the