Reseñas de clientes para VEVOR Cabina de Arenado de 927 L, con Tanque Presurizado, de Acero Resistente, con Tolva de Abrasivo 121 L y Colector de Polvo 1,6 HP, para el Acabado de Superficies de Piezas de Gran Tamaño

il manque juste la notice de montage mai pas très compliquer a monter non plus

Kabine kam gut verpackt und schnell an. Teile passten gut zueinander. Leider keine Aufbauanleitung in Deutsch, wodurch der Zusammenbau länger dauerte.

A lot of assembly, directions not that great. I took my time and it all came together. I did make one modification on the bottom I added a tee and a hose and connected it to the gun, instead of using the tube into a bucket of sand, it siphons much better. I have very little leakage of sand and I attribute this to a well assembled cabinet. I’m very satisfied with the cabinet. I did find the same cabinet at Harbor Freight for $50 less a month later.

Cabinet was easy to assemble and have used it several times already. I’m happy with its performance. The only complaint would be that the cabinet has to have a lot of blasting sand in it as the sand does not flow easily to the intake tube. Has this been a common complaint before and if so any recommendations. Thanks Lauran

This is a very nice blast cabinet for the price. I'm glad I found this one over what I was about to pay for the Eastwood version. The only reason I have it 4 stars is because it should come with a quick air disconnect for the outside of the cabinet instead of the press on hose fitting. Other then that a very nice cabinet

Will review after assembly and some use

Overall, it’s good for the price. We’ll have to replace one small hose. I can’t get to stop leaking. One of the YouTube videos I watched before I bought it, had the exact same leak.

Overall I am please with the blast cabinet. I had a little fit issue between the front panel notch and the left side where I had to make an adjustment. I wish to light was just a bit brighter. I have been please with the performance with my 6hp compressor but I know I can't run non stop. Not the cabinets fault. I added a regulator and drier to the air supply which should help with any moisture in the air. A fair amount of media builds up on the perimeter of the bottom frame keeping it from making it back to the sump. Again overall happy with my purchase

Kinda a pain to put together but overall work good with a 6cfm airmcompreser 120 psi.

Honestly this is a nice small blasting cabinet. It does the job I needed it to do quite well. Assembly was interesting but nothing too difficult. Works well even on my smaller 26gal air compressor. I can only think of two complaints with this unit: 1. As with many others, the tube will pull the sand out until its created a hole in the blasting media and you have to re-shovel everything over the feeder tube. 2. The air connection to the blast gun is a hose and clamp. This results in leaking air due to not having a tight seal. Still working out the kinks of this one and how to solve it.