Reseñas de clientes para VEVOR Bidón de Gasolina de 20 L, Tanque de Combustible de Metal y PP con Pico y Asa, Caudal Máximo de 6 L/min, a Prueba de Fugas, para la Mayoría de Autos, Motocicletas, ATV, UTV, Verde, 2 Piezas

I was happy with the price on these 2 Jerry cans, but the short plastic spout, rather than the longer, metal gooseneck spout leaves a lot to be desired. Had the opportunity to help my daughter when she ran out of gas, but the spout is so short that the metal edge of the handle was right up against the car, scratching it. Did the same to my car when testing it out. A longer, metal gooseneck spout would have been a huge asset.

Received wrong product and can’t get the gas cans!

A la première utilisation, les 2 becs verseurs ne sont plus étanches et ne coulissent plus. Les jerrycans en métal sont ok, mais sans les becs verseurs, ils sont inutilisables. Les becs verseurs avec arrêt automatique sont une très bonne idée, c'est ce que je recherchais, mais la qualité est nulle!!! Très déçu!

Was not as advertised.

the safety feature that is used to prevent unscrewing the filler/funnel were broken on both fuel cans IN THE BOX! I have not used these cans yet. If you were counting on this feature to prevent a child from opening the filler, DON'T. This particular feature is very poor! I will be using these cans this weekend as this feature is not needed for my use.

Unfortunately the item got lost in shipping. Never received them.

Dude there where metal shavings in my tank!? What the hell? What if i used this on somthing without a strainer? Cant upload a puc because you guys reqire me to convert the image and make very tiny 🤦‍♂️

It looks like the real Jerry can, but it is thin metal which can't withstand the pressure of expansion with a 30 degree temperature change. I filled it in the morning at 68 degrees and it got up to 96 degrees for a high. the cans deformed to the extent that they do not sit straight, and the sides are bulged out. I also had two 23 year old Jerry cans that I got in Germany and they had no problem handling the pressure. Also the paint runs if you spill a little fuel down the side. The cap locking system is cheap plastic and flies off with in a few uses.

The can is well built and I'm happy with the construction of the base. However, I can't say the same about the spout and seal. It leaks when trying to pour in holding down the childproof button. Ive tired tightening it down as far as it can go, and it still leaks. The spring on the lid popped out on the ratcheting side to tighten down. I feel the plastic and lid seal is poor quality, so if you need to pour out, don't use the childproof spout.

Not a standard Jerry can pouring nozzle it's like a gas can. 1 out of the 4 cans I purchased can't sit flat on the ground. Last it should have side handles so you can pour it easy.