Reseñas de clientes para VEVOR Prensa de Bloqueo para Fresadora 12,7 cm con Base Giratoria de 360 Grados

Average vice, used it on my small milling machine. Found a crack on one of the bolt holes on the fixed clamp head, when I disassembled it for cleaning. I could fix it though, but don't know if it has the same strength......time will tell

Seems good enough quality for the price. I had to de-bur it a bit, but not much. The keys don't line up parallel with the fixed jaw.

This is a pretty decent vise for a light weight milling machine or drill press. if you have a medium to larger machine, the castings are a little thin for agressive cutting. As compared to my Kurt, there is maybe 60% as much metal in the vise, which does translate to less strength. If you are using a standard bridgeport style mill the will probably be a solid choice. if you have a 7hp+ cnc, you may be able to break the vise with a heavy cut or at minimum experience some flexing that may cause trouble. In terms of dimensions, my example was well made and accurate enough for most things. Machining to +/- .001" per 6 inches is doable. Held parts square to about half that tolerance, which is ok. As with all tooling, you will need to invest time setting it up to be accurate. Wish it were made a little thicker, but it is a lot of vise for the price.

Very good price over quality. Arrived fast, well pakaging. It is heavy enough in order to give that stbility without vibration we are all looking for.

Works as intended. Vice is sturdy and is on my mill now for a few months haven't much to complain about.

It will do the job, But first there's a lot of work to be done. You must tear it all apart, every bit and scrub the hell out of it to get the cosmoline packing grease off of it. After a few hours of that break out the files and take all of the sharp edges off. And after a few more hours of that you need to oil and grease the lead screw and thrust bearings, then after that you get to start lapping the swivel base to true up the mating surfaces before you can think of bolting to your mill table. My time is money, and I'm invested deep before I can even use it. Yes after all of that it's a damn good mill vise.

Bon produit, dommage qu'il ait reçu un choc, heureusement au niveau de l'hexagone de la poignée, un coup de lime devrait régler le problème

For this money it’s worth the buy

Muito bom para o fim a que se destina ..

For the price it's tough to go wrong with these. Was easy enough to measure and make some soft jaws.