Reseñas de clientes para VEVOR Accesorio de embutir para prensa de taladro, 4 brocas, kit de cincel de orificio cuadrado, juego de localizador de brocas de banco, herramientas de embutir y espiga con 5 bujes, para carpintería

It didn’t fit my drill press so I had to get some adapter parts. Eventually figured it out.

Bought this for my Harbor Freight 10 inch drill press. One of the included collars seemed fit, but it would not slide up into position. Had to modify collar to fit. Once, it was set up, it worked very well and cut very nice mortises.

The product looks good but the inside diameter of the mount is just a bit too small to fit my drill press. Until I can figure out a way to mill it out a bit, I can't mount it and try it out.

Im Grossen und Ganzen bin ich sehr zufrieden mit dem Produkt. Einen kleinen Abzug gibt es für die Verarbeitung der Aufnahmen: An einigen Stellen sind scharfe Kanten vorhanden, die zunächst entgratet werden müssen. Zudem fehlt dort leider stellenweise die Farbe. Für ein Hobby-Projekt ist das Produkt absolut geeignet. Für professionelle Arbeiten hingegen eher nicht, da die Aussparungen nicht exakt viereckig sind, sondern durch den etwas größeren Bohrer noch leicht abgerundet ausfallen.

L'outil répond à l'usage attendu. Vrai bémol : la longueur des forets est surprenante : j'ai du les raccourcir de 4 cm pour qu'ils puissent être acceptés par le mandrin ...

I have not had an opportunity to use this tool yet however it is well constructed and well packaged in a suitable storage kit I am sure it will perform as described

Collar that came with the ordered item is mismatched due to the smaller collar size. The collar size is just two and a quarter inches in diameter whereas 3-inch diameter there exists on my machine.

I bought this to make mortis and tenon joints for 3" x 1" oak stained glass windows. It won't clamp anything larger than 2" to be mortised, it's too long to fit my 10" Ryobi drill press, hole pattern for the fence is too large for a 10" table which limits your distance to the centerline. I had to use a 5/8" space to get to my center and raise the head of my drill press to get room enough to do the job. I wound up just using the fence with a 5/8" spacer and my 1/2" forstner bit to get my mortises done. They say it's a universal fit, I disagree, if you've got a floor drill press it should work fine, just don't expect it to be a slam dunk on a bench mounted drill press.

Great quality built tool but didn't fit my bench drill, needs smaller collars or more adjustment options.

It did not fit my drill press. I had to make minor tweeks for proper fit. by usineing a plastic soda botel I cut a shim to take up the excess space