Reseñas de clientes para VEVOR Abrazadera de Horquillas de Tractor 109 cm Abrazadera en Horquillas de Paletas Carga de 907 kg Barra Estabilizadora Ajustable Horquilla de Paletas para Carretilla Elevadora con Pala Cargadora

Received the item and the bolts needed for the lower link were missing instead there were pins. This absolutely is incorrect I had to buy additional bolts to use for the lower link

Bought these about eight months ago and the cross bracket cracked the first time I used them. I've only used them a few times since but just did and the bracket broke completely.

Parts fairly heavy considering the cost. The pins to attach to 3 point hitch useless. It should come with proper boltst that attached to the 3 pt hit hitch. The bracket for that is weak point. If adding in cost to replace pins will not make it the good a price. If wanting to use with quick attachment bracket needs additional parts too. Somewhat satisfied.

Its hard to keep them for moving back and forth you can’t tighten them enough t on keep them from sliding under pressure

The bolt down clamps are way too cheap made. If you have a decent cutting edge on your machines bucket, it won’t clamp down enough

They ok not to good on your bucket..

Les fourches ne font pas la même dimension

Unfortunately, today is the first day. I’m trying to install my forklifts on my bucket after owning them for about two or three months this mistake. I should’ve tried to put them on the very first day I got them anyway I just tried installing them and unfortunately, it only takes one bad apple so one bolt out of all four is crossed and it will not allow me to loosen it no matter what I do. The bad thing is you have to have this open one to 2 inches before I can slide it over my bucket so now it’s staying there impossible to install this without potentially cutting this securing bolt off. What am I to do? Not really sure how this is going to pan out. This is definitely a quality control problem. Someone should’ve screwed this in and out before they ever got shipped.

The holes for the three-point-hitch pins are approximately 2-3" off the ground. No 3-point hitch goes that low, so at the lowest setting for your 3-point hitch, the pallet forks are about 6" off the ground; you can't scoop up a pallet!

I purchased these forks to lift pallets and other things on my Massey Ferg 1742 tractor. They work OK, but it is an absolute pain to get them attached and oriented properly, and despite my best efforts and strength, they will still shift under heavy loads. They are definitely built with solid metal, though the welds are not stellar. They weigh a lot, so be aware 1) when the package comes and 2) when you are fitting them. I absolutely HATE the 90 degree, 4 inch long arms on the top of the tightening bolts, because you sure as heck are not hand-tightening if you think you will keep the forks secure/in-place. After hand tightening, I have to use an open end wrench on the 90-degree and then a 1 1/4" open end to tighten the adjustment nut on the bottom before it has any chance of not moving (but it still will). Also, the stabilizer bar that goes between the forks is helpful, but when moving pallets it has to be all the way back to the stops, near the bucket, so it is only moderately useful. Overall, I am satisfied with the performance based on the cost, but don't kid yourselves (or watch the paid youtube reviews that make it look as smooth as silk), these forks are a challenge taking on/off and are not anywhere near as stable as a dedicated fork attachment.